I bought a thermostat replacement kit for my 89 90 hp evinrude. My ?? is do I need to use any permetex sealant on any of the gaskets provided in the kit? Do I just reassemble and tighten? What about the 2 rubber hoses on the ends. Should i use sealent there too?
pulled the plugs and found very different conditions on plugs. gaps are the same but dont look like proper combustion. any ideas on where to start. carb has been rebuilt and compression is also not the same in the cylinders. 90psi and 140psi. do i have a rebuild project this winter? This is a...
so connect red and purple leads to battery. fuse the purple with what size fuse? It seems that regulator /rectifier is putting out 24v dc will that damage battery?
I have a 2000 rope start, tiller handle model e10r4sse it did not come with electric start. I have measured voltage from a plug that comes out from under flywheel and I get 70v ac at idle and increases when revs up.there yellow wires and from 1 wire to ground its around 30 v and other is 28v and...
motor was running rough after warming up,so pulled plugs and found this. there not the same,is there an issue with the on cyclinder? these are from a 2000 9.9 4 stroke.I have had problems with what seems like a fuel problem( starts to struggle for fuel) pump ball and comes back up but not for long.
I have a 89 90hp evinrude with power tt the motor is making low groaning noises and working intermitenly . no leaks and fluid is ok. I think it might need a motor replacement any help in that process would be great thanks.
89 gls with 90hp evinrude. I need to know if this horn is supposed to "beep" when key is turned to run ---just prior to start, it does alarm when grounding temp sensor, so the horn does work.
great forum,been searching for this answer but cant find one. here is my problem 89 sea nymph boat with 90hp and vro still working, that has 3 wires coming out of it. 2 overheat sensors in the head that has 1 each.I should have a beep with key in run position, prior to start but I don't. I did...
