FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
I have a 5.7 357 Magnum 2012 Bravo. I'm located in a cold weather climate and I store it on a lift for the winter. In the past I've always had the marina come over each year and do the engine winterization but the marina recently closed so I'm probably going to do it myself this year. I have...
I have removed the pinion gear off the drive shaft but cannot pull the shaft up far enough to remove the forward gear. The shaft will move slightly up & down but the shaft bearing will not fit through the hole on the upper side of the lower unit. The pinion gear and forward gear were both...
I have a 1989 60 hp Johnson. Just replaced the stator (from Iboats). While both wiring plugs were the same 5 prong; the old plug had 5 wires going in; 4 from the stator and one other from another direction. The new stator (which I know is the correct one) had the same plug with the 4 stator...
I have a 1989 60 hp Johnson. Just replaced the stator (from Iboats). While both wiring plugs were the same 5 prong; the old plug had 5 wires going in; 4 from the stator and one other from another direction. The new stator (which I know is the correct one) had the same plug with the 4 stator...
