I have a 78 evin.85 hp o/b.I was having tilt and trim switch problems so took the shifter apart,after putting it back together i can't shift.Took back apart and together several times and still have the same problem.Just a note, i didn't have any gear oil in all winter and during that time i...
On my last post,and previous posts you have said to try and equal pressure by either the nut job,or by the punch.I tryed both these and couldn't get zip.So after a rum & coke decided to take the other end of release valve out(from the backside).Upon doing so there was so much pressure in there...
newbie question.<br />I have a 1979 85hp evinrude o/b.<br />I have a manual for said engine but in this manual it does not show anything about tilt and trim.If anybody has any type of info it would be of great assistance.<br />I'm trying to reseal the tilt and trim.Or maybe even rebuild.<br />My...
I have a 79-85hp evnrde and just can not get the trim to go down.The electric motor is spinning and just nothing happens.The manual release works.So,i decided to take out the check valve?<br />Put it back in,and now i get nothing.No tilt no trim.I'm wondering if the hydraulic seals are shot and...
I have an 79/85 hp evinrude o/b.<br />I haven't been able to trim down for sometime.<br />I replaced the motor(electric) because i wasn't get any power to trim down.Installed new motor and still get tilt,but my disapointment no trim.<br />I feel it is time to have somebody replace a seal or two...
First,i'm new to boating.<br /><br />I keep hearing people say "run engine with hose",i was wondering how to do this so i can tune engine?<br />I'm also need to know the best place to buy a new check valve for trim&tilt on a 79 /85hp evinrude o/b.<br /><br />Thax trev
I have removed the check valve from my hydraulic tilt and trim and discovered that it is now in two pieces instead of one. Is this correct? <br /><br />1980, 85 hp evinrude 0/B <br /> <br />Another question.<br /><br />How much hydrualic fluid should be put in as there seems to be no window to...
I have a 85 evinrude outboard.I've installed a new electric motor for the tilt and it goes up perfectly, but i can not get it to go down unless i use the release screw.Please help!! :confused: <br />I think it is an 79 or 80.And yes the electric part of it does sound like it is working...
