Hello, The paint is peeling off the top of my 25hp 1998 Honda. Its the piece on top of the cover that you use to tilt the motor. How do I remove the rest of the paint on this piece and how do I prepare the plastic surface for painting. I have Honda paint and clear coat. thanks, Tom
Hello, I have 1997 Honda 25hp,tiller,manual start on a 15ft jon boat and I would like to install a water fuel seperator. Would someone recomend one for my Honda. Also are there any installation instructions on the internet. thanks,Tom
Hello, Does it hurt anything to run the outboard without a thermostat temporary only? I had overheating problems and have since changed the impeller and checked the themostat, it opened at 160 degrees.
Hello, I dont have a dealer near me and I need a oil filter for my 25hp. Would a Wix filter be OK and would someone have a number for the Wix? I couldnt find it on the Wix filter lookup. thanks
Hello, How do I set the timing at idle. There is a screw that stops the timer base as it returns to idle. I think it has been messed with before we purchased the motor. The Seloc manual dont address this adjustment? thanks
Hello, I am working on a 1972 Evinrude 50 hp. When I pull the remote control back to idle position the throttle cam is about 1/2 in. from the follower on the carbs. The manual says to adjust the follower until it lines up with mark on the cam. However I dont think I have enough adjustment for...
Hello, What size fuse do I need for the ingnition wire. Its a red wire with a black rubber fuse connector. I think the fuse one that was there is too short. thanks
Hello, I am working on a 1972 50hp Evinrude and I noticed that the fuel pump is mounted on the carbs air box not on the engine block. What makes the pump work. thanks
Hello, I just checked the Ohms on the trigger and got "OL". I removed the white and black wire and the black and white wire from the power pack and connected them to my Ohm meter probes to make this test. All the info. I get is that I should get a reading between 10 and 20 Ohms. If the reading...
