Lol ok I was tryin to figure out trim up I thought would be middle and top but that’s trailer.
now it’s working again when I push middle and top so not sure what’s dirty but it’s getting better or something idk
Ok I found a wire without a fuse in it the red wire from bottom jumps up to the middle button
I hooked those together and it worked when I push top and middle. Nothing just pushing top
Now. I tried again and it didn’t work. Then it did. Now I hear it click? Back by motor when I push...
Ok I think I found the problem but not sure.
the blue wire has a split but it goes to nothin
I found a purple w white stripe that has the same kind of connector but goes to nothing.
mic I look at the ends of them the wire coating is brittle and comes off are these spose to be hooked together...
I have to be missing power at the middle button coz I’m not sure using the middle button matters as far as making it go down ya know?
gonna see if I can get under dash to grab some testing on the switch buttons now
Ok I’m on it 👍🏻
I know there’s 2 loose wires from the trim senders on outdrive. And another two loose
Wires with a bullet connector and a ring connector. I never really worried about making the trim tabs work right coz I never trim it while boating. If it’s a have to to make the drive go up...
Also the black wire on B one is a short wire that screws to the motor housing the other goes to the neg on battery. Not sure how it’s a ground issue. Unless I confused myself don’t it mean the sol is bad if u run power to C and it works? Or is that mean ground is bad? I never took the end of...
