So this is the second time this has happened... First time I thought it was a bad solenoid...
It's in a Merc 350 with thunderbolt IV.
Replaced the solenoid the first time and the motor kept cranking over after I turned the key off.. Melted all my cables... Destroyed my battery Switch and...
Having WOT issues with a 211 Liberator with 5.7 Merc.
Currently have 14.25 x 21
Would Would I gain...or lose...but going to 15x19?
Four winns tells me 14x19 came on it, but I recently found a nice prop used (15x19) and wanted to ask first, before I throw away money...
Thanks.
-Tom
I recently purchased a 1985 Liberator 211, and I am trying to get things in shape.
Cockpit came in great shape, cuddy cushions are a little rough, but all in all a pretty decent boat.
There are a few things I am trying to get for it that came stock, but are gone now. Any direction would be...
So first off, I searched....and I am not sure if this is even the correct place to post this....
Low WOT...(I know I know...)
Full tune up, filters and timing is good, but I am still getting low WOT...
It is a Mercruiser 260 (5.7) 1985 with Thunderbolt IV Ignition, in a Four Winns...
Re: 3.0L still cuts out after replacing almost everything all my searching has told m
Figured I would share some pictures of what I am working with...will get better ones later...
First Id like to say I have a member for a little while now and have been searching this subject since Day1...
I am by any means no expert on boats but have a decent knowledge with Car/Truck motors and as much searching as I have done on here I had to post for myself instead of basing my...
