Hi guys, So my boat's been in the garage for the last couple of months as it was winter in Melbourne, Australia, and when I picked it up to check that it was in good nick I noticed a small puddle of gearbox oil had leaked. The leak appeared to be from the small vent holes on the underside of the...
Re: 92 Force 90hp - tilt/trim problems, blowing fuses.
Sorry to revive an old thread, but I finally figured out the real problem, and thought I'd not leave anyone in the future reading an incorrect answer.
Everything seemed fine after replacing the relays, and worked well through every test i...
Hi guys, I posted a while back about my motor having some issues and thought they were resolved but apparently not. Anyway, I had to get towed in by the cops after a fuse went in the outboard, and I foolishly didn't have any spares. This happened after an unusual event with the trim - i was...
Hi guys, I've been getting blown fuses in the tilt circuit and I want to replace the two wires that go into the tilt/trim motor. If i have the engine lifted above the trim part of the tilt/trim system, so that it's not using the hydraulics, can I take the cap off where the wires go in without...
Hi all, I've lurked around this site for a while without signing up because I've never had issues and I've never had anything much to contribute either. I picked up a runabout with a 90hp Force on it a couple of months ago, after owning a tinny with a massive 6hp merc on the back since I was 13...
