Recent content by Vandkanten

  1. V

    Can my boat plane?

    I have a Dory 13 with a Evinrude 35 HP 3cyl engine, short shaft. I am not sure how I get the boat to plane, I slowly increase speed but it wont plane ? I took some pictures. Any suggestions.
  2. V

    Video, why does my E35 behave like this?

    Fresh compression numbers is 110,110,120. Tested on cold and warm engine. New plugs. All 3 carbs is cleaned. Running premix. The engine can run on 1 cyl by disconnecting the other two cyls. I have testet, it can single cyl run on each of the 3 cyls. I had the engine running for about 30...
  3. V

    Trust the wire colors or the length?

    I have changed the CDI pack for my 3 cyl 35 hp Evinrude. My old CDI Pack have 3 wires, 1: (A short wire, Orange/Green) went to bottom cyl. 2: (A medium wire, Orange/Purple) went to middle cyl. 3: (A long wire, Orange/Blue) want to top cyl. According to the CDI Troubleshooting guide the above...
  4. V

    Engine runs only when operating the primer/choke.

    I have an E35 from '99. I just got it started but I have to operate the primer/choke in and out to keep it running. When the engine almost dies I quickly pull and push the primer/choke and the engine runs perfect for about 3 seconds. Then again I have to pull/push the primer/choker and so on...
  5. V

    The purpose of this hole is ?

    Anyone know the purpose of the hole close to the peehole. ?
  6. V

    Bypass the Oil Mix system, E35

    Hi, Having a E35, 3cyl from 1999. I have read ALOT about I should get rid of my OMS/VRO system. Oil mixing system. And sure I will. But instead of removing the unit, I thougth of running with an empty oil tank and just do the premix myself. It is doable or should I remove it totally?
  7. V

    To ADMIN - Problem with website.

    Hi ADMIN, Thank you for a great website. Sometimes your website blocks me off with attached error message. I dont know if it by purpose or it is a mistake/error. Many greetings from Denmark
  8. V

    Stator/CDI alternative test

    I have an Evinrude 3cyl 35 HP 1998 outboard with no spark. I have read and seen alot of different test of how to test the stator and in generel test and diagnose your outboard. Well, it isnt that difficult. But everything gets alot easier if you had spareparts to test with. Right now I am...
  9. V

    Is my stator bad?

    According to the service manual I should be able to measure this on the stator output: Brown -> Brown/Yellow, 720-880 Ohm, 150-400 Vac I measure this: 750 Ohm, and 106 Vac when I crank by hand (A hard pull) I am able to measure max. 170Vac by cranking by machine at max RPM Even at 170Vac...
  10. V

    Should warning light up, when pulling the engine?

    I have a Evinrude 35 HP 3cyl from 1997 model E35KLEUR. My question is, does anyone know how the warning LED (located right at the rope pull) works ? Should it light up when pulling the rope/cranking the engine? And then goes off when the engine runs? Or do I have have an error that I have to...
  11. V

    Turning the flywheel the wrong way.

    Am I in trouble here? I may have turned the flywheel slowly by hand the wrong way around, only some rounds. Is this enough to destroy anything?
  12. V

    What is are these "things" on my Evinrude 35

    Hi, I have an Evinrude 35 HP from '97. I have the service manual but I can't seem to find any information on these 3 "things". Thing 1: Is a cork, when removed you can attach a small tube. But for what purpose? Thing 2: is a valve similiar to a air valve from a tire. But what is the...
  13. V

    Help, I have microvolts on black/yellow killwire.

    Hi, I have read that there should NOT be any volts on the black/yellow killwire. But sadly I have about 0,7 volts and no sparks. The engine is a 3cyl 35 HP Evinrude 1997, started by rope. Kill switch and wire harness is disconneted, so the killwire is floating in air. No batteries is...
  14. V

    Need advice for Evinrude 35 HP '97

    Hello, I have an Evinrude 35 hp, 3 cyl from 1997. Model: ~E35TKLEUR When I Brought it, it would not start (no spark om any cyl). I have replaced sparks and done the service manual tests. Cleaned sensors, grounds and tested the kill switch. It has rope start and I have succesfully started the...
See more
Top