Recent content by Vico

  1. V

    Will it hurt my power head and the engine?

    I tested the water thermostat yesterday on my 125HP Evinrude 1971 it was good. During the installation, the thermostat pin slipped from my hand and fell into the first hole from right in the housing (behind the thermostat) and from there into the hole of the exhaust housing ,I don't know where...
  2. V

    71 Evinrude 125HP prop spins fast on all gears

    After I replaced the water pump impeller,I put the lower unit back in place,refilled the gear case with new oil.I started the engine but noticed the prop spun very fast clockwise (much faster then it does when on neutral) could broke my fingers if tried to stop hold it. Prop kept spinning the...
  3. V

    I need a wiring harness!

    I have 80 HP old mercury and looking for the wiring harness for it with plug (internal) and the plug comes out from the side of the engine, 6 pins, anyone can help me with this please! ENGINE serial # 3428524 thank you
  4. V

    115 HP Johnson outboard 89

    piston is dead so i'm going to replace it with a new one, I need to know what other small parts to change along the piston,it's been sitting for 2 years now .
See more
Top