J175EXERA
engine sat for about 2 years and when I primed it with the primer bulb they started leaking . my question is there any special process to installing the new o rings ,,like greasing them or should they be installed dry
and
and is there an updated part to compensate for ethanol fuel
I was offered a pretty good deal on this motor,,,
I must say I have been skeptical on all the DFI Evinrude engines from the previous years 1999 to 2002.
Friend of mine got a few of these from a military auction some never been in saltwater,all these motors are gray in color and were used and...
On my Johnson outboard after running the engine on ears or in water for about 5 to 15 minutes once I turn it off I have a steady alarm it will only shut down if I disconnect the vro pump harness does not turn off when I disconnect the temp harnes
*What I've done*
New updated waterpump and...
In need of info of 1987-89 18'concept marine center console Yesterday, 08:39 PM
I need info on
18' center console.
so far I have found that Concept Marine and Concepts Boats are not related at all
Concept marine built boats form approx 1987 to 1990
center consoles
18-27 feet
Other...
I need info on
18' center console.
so far I have found that Concept Marine and Concepts Boats are not related at all
Concept marine built boats form approx 1987 to 1990
center consoles
18-27 feet
Other than that thats all i have
I hoping someone on the forum may have some second hand info...
Question Repower question HPDI vs. Optimax
Time to add new power to my 89 2500 Hydrasport WA need some of reviews on which is going to be better,or should I say reliable and fuel efficient. looking at twin 150's ,either Yamaha 150 HPDI or mercury 150 Optimax I have a line of a pair of each...
1996 200 carbed saltwater series non 0x66 the engine runs great but skips a WOT . Fuel consumption seems to be high 1.75 - 1 mpg. the seller took it to a dealer ship and they a compression test don't have numbers on hand and a leak down test and it failed The leak down numbers are listed as...
recently I have had a problem with a single coil on my stator its the coil that has the orange /orange blk wire going to the powerpack recently it got toasted i beleve this is pART OF THE QUIKSTART OR SLOWMODE GOING TO THE POWER PCK. my question what would cause it to fry I have replaced it and...
1995 johnson 200v6 looper recently had a problem with my engine charging system during the visual check I noticed the sensor coil on the stator was toast this is the coil with the orange / orange black wire on it after replacing the old stator with a new one the engine runs eratic I have to use...
I dont know how long this problem has existed but I noticed the sensor coil on my stator was burnt pretty bad the engine would still run fine but tach was also out .So i decided to replace the stator thinking it would fix the tach and the no charge problem I was having but after replacing the...
would I loose charge with a bad stator my stator has on of the larger coils loose and burnt looking seems as it will fall off if it didn't have the retainer holding it on engine still runs fine on a hot battery regulator seems fine not burnt at all last time it went out the regulator was...
