Recent content by vortec4.3

  1. V

    Mirage 48 13244 A50 21P.

    Hello .I got this propeller Mirage 48 13244 A50 21P but I lost nut washer and spacer .I would to know who selling the kit nut washer space to run it on alpha1 gen 2 .Thanks
  2. V

    Question on lower unit

    This guy tried to sell me this item. Is it an Alpha 1 Gen 2 or Bravo 1?
  3. V

    Bravo 1 lower unit can swap to alpha one?

    My Alpha 1 gen 2 lower unit is broken .Can I swap Bravo 1 lower unit to my Alpha 1 upper unit.
  4. V

    Aluminum exhaust elbow.

    i bought from this guy from 2 week ago he send me cast iron i just make return.
  5. V

    Aluminum exhaust elbow.

    HGE 3454A Is aluminum save lot weight on back of my boats, that why i would look to buy.
  6. V

    Aluminum exhaust elbow.

    Can you give me a link to the HGE website? I am in Nebraska. I also google it sold out .
  7. V

    Aluminum exhaust elbow.

    where can i buy online mercuries 4 in aluminum exhaust elbow. Parts# HGE 4354A.
  8. V

    89 OMC 2.3 TIMING MARK GO WRONG

    I working on 89 2.3 ,the timing belt slip away from the mark and boat hard to start. I replace new belt,the engine still hard to start and when it run like no idle I use timing light check the mark on pulley show away from the mark on cover like 32* I try turn distributor back to 10* the engine...
  9. V

    4 blade ss 23p 52 mph w.o.t

    my boats 17ft 350 vortec lt4 cam .elder rock cab 1409,est ignition ,timing @total 30* drive unit 1.5 alpha1,I was test drive today , the boat hit 52 wot @ 4000 rpm,i think I did not had right prop, or some thing set up not right, would some one help, because I look over online I saw one guys had...
  10. V

    mercruier exhaust elbow

    mercruier exhaust elbow v6 and v8 the same would you tell me,i am plant going v6 to v8 thanks
  11. V

    swap v6 4.3 to v8

    I would like go up to v8 during my 4.3 blown up, any one here done with v6 to v8 please let me know what parts need to be change. And after done the boat run good or not.....my boat 17 ft. with factory 4.3 gear rotor 1.62.give me the idea stay with v6 or go up to v8 I know I ask crazy ,,,,,and...
  12. V

    gasket sealing help

    I working on omc gimbal housing,did any one tell what stype of sealing to used on there,where do they sell it.and what is the best brand thank again
  13. V

    4.3 with holley 650 double pump

    can I use my 650 cfm holley double pump on vortec 4.3,what I need to change inside cab like jet or power vale,to make it run good with my 4.3 vortec,and I know it car carb , thanks alot
See more
Top