Engine starts then dies after about ten seconds of running. The fuel bulb is soft but pumping it to try and keep the engine running does not help.<br />The engine will restart then die again and again<br />Any ideas?
I have replace one switchbox because 2 and 5 were not firing. All of the plugs are now firing when grounded to the engine.I have replaced the fuel hoses back to the tank. I have rebuild the fuel pump and new floats and needle and seats.<br />I have checked the resistance of the stator with the...
Can anyone tell me what type of plastic fitting I can use to replace the plastic hose to pipe fitting at the fuel tank. The pickup line is made of alumiminium with a plastic connector?<br />Can I use a nylon connector?
Can anyone tell me what type of plastic fitting I can use to replace the plastic hose to pipe fitting at the fuel tank. The pickup line is made of alumiminium with a plastic connector?<br />Can I use a nylon connector?<br />Thanks
1984 90hp mariner SN6399108<br />How do you test the stator without a peak volt meter?<br />Can you use a scope to look at the peak voltages?<br />Thanks
I have a 90hp 1984 inline 6 Mariner outboard<br />How do you check the resistance in the stator and the trigger coil to insure they are ok when you have a spark plug not firing. I think i have a bad switch box but want to be sure. <br />Can you replace one switch box at a time or only in...
I have a 90hp 1984 inline 6 Mariner outboard<br />How do you check the resistance in the stator and the trigger coil to insure they are ok when you have a spark plug not firing. I think i have a bad switch box but want to be sure. <br />Can you replace one switch box at a time or only in...
I have a 1984 mariner inline 6 90 hp motor with no spark on cylinde #3. I tested the no spark by removeing all of the plugs then cranking the engine with the plugs grounded. There was no spark on plug no 3. So I then changed the coil wires between coils 2 and 3 and then plug #2 didnt have any...
