Hi, I just put my boat in the water after purchase....It ran fine except for bogging down at full throttle. I would back off a bit and it would run perfect, then the next day it was running rough at all stages of throttle.....and by that evening it just wont start!
I forgot to put stabil in the...
Hi im thinking of buying a 19ft Spectrum aluminum bowrider with a 2.3l inboard.
My towing capacity is 2000lbs on my car i think i saw somewhere that the boat weight is 2100 but again im not sure.
will adding a tranny oil cooler and better brakes be sufficiant to tow 100 lbs over my limit or do i...
My motor isnt cooling the impeller is new the housing is fine they key is grabbing the impeller water is filling into the system but wont get to the exhaust. removed thermostat and can pump water and it falls out the intake what am i missing??
maybe a peice of the old driveshaft stuck blocking...
Hi my motor stoped cooling after my driveshaft was replaced
impeller pump housing are ok water lines are connected mechanic suggests seal kit and grommets for water lines. any ideas??
Hi I have a couple questions, first what size shear pin do i need , second my mechanic just changed the driveshaft and noticed the shift fork and the thing it rests in are damaged but will take 3 weeks for the part im going fishing this week. is it okay and what can i do to baby it?
Thanks Chris:)
Hi
I have a 1965 Johnson 40hp i was driving wot and the motor jumped out of gear reduced revs shifted to neutral then back in drive and it went fine again did it 2 more times that day. then the next week it did it again and wouldnt go back in forward or reverse. after opening the lower unit...
