Hello all,<br />I am replacing gimble bearing and bellows on a OMC king cobra 460, '89 Four Winns. Have done several Mercs, first OMC. I am trying to figure out how to disconnect the lower shift cable. I cannot access it from inside the boat and was wondering what type of seal there is at the...
Hello<br />I replaced the water shutters on my 454 / Alpa 1 a while back and when I removed the old ones, the starboard side was only half a shutter. What I'm wondering is if it is stuck in the y pipe or did it make it out somehow. I know that eventually it will wear a hole in the y pipe...if...
Hello, I have just replaced all of the bellows, the water hose and the gimbal bearing in my 454/alpha one (87). Checked alignment with an old drivesaft, good and smooth, lightly sanded the driveshaft where it meets the gimble bearing and greased it also. When I installed the out drive it was...
Hello, I am hoping somebody can answer a few questions I have. My 454-Alpha one is leaking from the bottom of the transom plate, I'm assuming the o-ring type seal is bad from the outdrive bouncing on the shore during a windy trip to the lake. I have eliminated the bellows from being at...
