Recent content by weloveour7dogs

  1. weloveour7dogs

    omc 400 shift cable

    Re: omc 400 shift cable this is the brass piece I didn't know if I could put it back on if I took it off...no sense in spending more than I need to. HAHA
  2. weloveour7dogs

    omc 400 shift cable

    I have a 79 omc 400 outdrive that needs to be swapped out, I allready have the replacement one. the problem is I need to use my old shift cable (guy cut the one on the replacement) I can't feed the shift cable through the mid drive with out removing the brass keeper on the end of the shift...
  3. weloveour7dogs

    1976 55hp johnson carb rebuild

    I rebuilt my carb doing everything it said in my Seloc manual. I'm at the point of reinserting the needle bearing valve and it does not fit into the low speed idle adjustment. The Seloc manual says it should seat inside but it doesn't go. My question is - Is this something that I really have...
  4. weloveour7dogs

    Fuel pump?

    After a long respite in the garage (and a new tilt motor and carb re-build), the Hustler is finally fixed and river-worthy...or so we thought. After a trouble free jaunt down river we turned around and headed for home. As soon as we got it full throttle and opened up, there was a pop and it...
  5. weloveour7dogs

    New here from Iowa

    I am new here to the forum. my name is Ben, our family lives in Iowa, on the mississippi. We have a 79 Hustler and a 76 Flote Bote, neither one is useable at this time.:mad: Love going out on the water, swimming, tubing,fishing, and just living the beach life. Looking forward to learning more...
  6. weloveour7dogs

    1979 Lark Hustler tilt problem

    I have a 1979 Lark Hustler. 140 HP OMC motor. My problem is with the tilt. bought a replacement motor off of ebay, http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=110499057149&viewitem=&sspagename=STRK%3AMEWNX%3AIT with the motor installed it just clicked and didn't do...
See more
Top