rebuilt carb 2bbl rochester, adjusted fuel air starts soon as you turn key. The problem is on cold start I turn the throttle on to set choke and when it starts it runs about 3500 to 4000 rpm until you mash the throttle to release the choke and it will idel down. but I kn ow this is not...
I have an oil leak on the outdrive just below the trim rams and looks like it is coming out the seam where the lower unit bolts up can anybody tell me why and what to do to fix it. Here is a pic to show where the leak is and the flow of oil downward.
I brung my boat out of winter storage and I have a 3.0 liter with alpha one outdrive and I have oil on the fin where you would mount a stabilizer to it I don't know where the oil is coming from or why. Can someone have an answer for it??
please help!!!!
I have a 1989 3.0 mercruiser, the problem is it takes about 5 minutes of cranking to get it to start, Doesn't matter if I pump the throttle a couple of times or I give it just alittle gas and start cranking. after all the cranking I have to open it wide open and about 15...
I have 89 rinker boat with 3.0 with mercruiser outdrive. Runs great but when I turn the boat left or right it gets louder and vibrates alittle bit what could this be and why?? please help!!
what color of spark should you have? I have an orange spark, should it be blue?? Won't start could it be a weak spark?? got fuel got orange spark and good compression
3.0 getting fuel and spark but won't start, the spark is orange on all cylinders, is that too week of a spark or is there something else I need to look at
I have 89 rinker with mercruiser 3.0 and I noticed my exhaust is coming out where my out drive is connected to the transom and not my propeller. What is the rubber gasket called and how can I find a replacement?
I have a 1989 3.0 with a 2 barrell carb and on my carb the number is stamped 13899562 and directly under it is 8602. I tried to get a kit for it but none of the numbers match up with the carb kits. What kit do I need for this from the Iboat store??? thanks
I have 3.0 mercruiser alpha one outdrive. I was going to winterize by muffs and a tub with antifreeze and a pump, but now my carb is overloading and pouring fuel into the cylinders. just will not start!! So now I don't want to rebuild the carb until spring and need to know if I take off the...
have a 1989 3.0 mercruiser turn the key and crank and crank and crank then just when I start to release the key it starts. Don't know why??? also is it worth it to convert to electronic ignition and how much does it cost.
how hard would it be to change the out drive impeller water pump. Just got my boat out and found out that it is overheating and there was plastic pieces down under my fins where the water intake is. I am mechanical inclined
I have 89 rinker and the trim motor has the plastic tank mounted below it and the tank seams to have movement back and forth and there is no way to tighten because of the mounting brackets for the unit comes down each side of tank so you can't turn it more than a 1/4 turn. Is this normal ?????
