Recent content by Wildman_fab

  1. W

    1994 225 studders at high RPM

    I have a 1994 Oceanpro that has been giving me fits recently. New fuel tanks, new fuel lines, new racor (emptied it out just to check and it was clean) dumped the float bowls first and there was no water in there either. The flywheel has been replaced and the magnets are in good shape. I have...
  2. W

    Evinrude extension 'kit' and water pump

    Lets start off by saying the Bay MFG kit's directions are less than adequate... and thats putting it lightly. They suck. The other problem I think I am having is there are missing parts (o-rings and seals mostly) in the motor to start with! I have no idea how this thing didnt overheat. I have...
  3. W

    Oceanpro Flywheel magnets

    I have a 1994 Oceanpro that has been rebuilt and running great up untill last week. My boat sunk (but the motor didnt go all the way down) I bumped the key 2-3 times before realizing there was some water in the lower cylinders. After getting it home, I gave it a good wash. After fogging the...
  4. W

    Oil box alarm? 225 Oceanpro

    I have an odd alarm happening. 1994 225 Ocean pro I run the boat out, 4-5miles full throttle, or almost full, no alarm. Fish all day at an idle, start running back in, its a little rough, bumpy and I get an alarm. If you back it down to 2000 RPM it will turn off. The VRO pump is clicking...
  5. W

    225 ocean pro studdering around 3K rpm

    Just like the title says, I have run my 1994 225 ocean pro on the hose about 6 times, and out in the water a couple times. Out in the water it has a slight shudder, or studder just about 3000RPM. Bad enough to make me worry and shake the GPS on the console. Above that she jumps right up, and...
  6. W

    Engine install questions

    I just installed a 1994 ocean pro 225 on the back of my Mako. We got it all pluged in, primed and she fired right up! After that we tried to hookup the tach, and no dice. The needle droped down to zero after starting, but never registered anything else. Last weekend we ran it and it went...
  7. W

    225 Ocean pro questions

    I bought this motor a few weeks ago and have started to hook it up. It came with a crate full of wires and just about everything that I can tell is there. But I still have a couple questions, What is this black 90deg fitting on the lower part of the block, there is an alen plug on the oposite...
  8. W

    Rigging tubes for Ocean pro?

    Is there a way I can get rigging tubes to adapt up to my 1994 225 ocean pro? It has the little slide in rubber piece that the fuel lines and controls would pass through. Any ideas? I like the look of the rigging tubes on the Yamaha's!
  9. W

    3.0L merc Hot start issue?

    I have a 1988 3.0L alpha I that runs VERY sweet, plenty of power, smooth, revs right up good. The problem I have is with a hot starts. I can throw the muffs on it in the yard and touch the key, it cranks 2X and fires right up. Once I get it off the trailer at the ramp it will crank just fine...
See more
Top