I just finished rebuilding three gunked carbs on a 75 HP ELPTO with the help of this forum and the service manual. Getting ready to put things back I see two sets of torque values for the air attenuator bolts/studs-nuts. In section 1 (Specs) they are called out at 100 in-lbs; in the power head...
just wondering if anyone has tried this.
seems every time I get ready to take my boat out something comes up and its weeks until I can get back to the water. Living in Florida, the gas evaporates from the carbs real fast leaving gunk behind. I was wondering if I can save my self a carb teardown...
I have the service manual for the 2003 75 hp elpto (serial OT673179)
which says initial carb settings after rebuild are :
CYL #1: 1/4 turn
CYL #2&3: 1 and 1/4 turns.
Can this be right?
Seems the #1 CYL would be very lean at idle (which I do a lot due to manatee zone all over the...
