Looks like the cut wire belongs to the heavy white terminal next to it and since its a fuse wire, it must be the power terminal to the battery. thats my guess. A schematic helped alot. I'll put power to it and see what happens once that white wire is in place.
So far I see the wires are for a Tac and Trim gauges but cant find anything on the third set and that set has 2 caped off ends there at the bottom of the pic. Ordered new cables at the correct length. Now if only I can make the controller accessory setting put power to the trim motor and the...
Hello good folks at the big I. Well, I bought this motor, saw it run in a water barrel. "seemed" to start & run OK despite not knowing jack about outboards on my part. Once I got it home and looked it over, I see where some one had written 112, 114, 114 right near the plugs. So After looking...
I didn't have any problem seeing the spark when spinning the engine over. Finally got the engine and control all off the boat yesterday and on a stand up rack. Putting it on face book to see if any one wants to buy it as is. The bolt heads and gaskets look like its been rebuilt as some point...
OK I think I understand what your saying. The key switch has the black with yellow grounded in its off position, in "run" it opens that circuit. So the jumpers I pictured are actually meant for a kill switch that was once in that hole above where this jumper cut in the wires are. Many Thanks...
No, it has a rubber type conduit with wires individually going to separate terminals on the engine and threw out to the battery and controller. I wish you were right on that! The Factory Fabuglas spec sheet says approximate boat weight is 500 lbs for my 146. The Trident 154 is 650, trident 170...
MANY thanks to Crosbyman for digging up the schematic! Now, am I reading this right. It looks like if I close the purple with white and black with yellow that come off the switch, I should at very least see spark at the plugs providing the speed controller is functioning in its neutral position...
Its a Johnson 65 Powershift II
In this shot, they put on a wire off the black with greenish stripe wire and put another off the black (ground?) wire. they were both just snipped clean on the ends. I stripped the ends and found no power in the striped one to jump. I guess I have to open up the...
So the back ground is I bought this can of worms at auction on a 73 Fabuglas 146 and the Johnson 65 hp engine is unknown running condition. There is no key but there are 2 wires have been cut from the control cable wires that are black with stripe and 2 short sections come off each as these were...
