Recent content by yeos

  1. Y

    Adding bilge pump, no access

    I've got an old Pacific mariner runabout. There is no access to the hull of the boat and I would like to add a bilge pump. Only a trickle of water gets inside when I take it out into the sound, but when I wash down the deck afterwards water does enter the bottom of the boat from the deck and...
  2. Y

    zinc anode location 1977 johnson 35

    Where is or should a zinc anode located on my outboard? I don't remember seeing one on it while servicing the lower unit.
  3. Y

    1960 Pacific Mariner runabout raising transom height

    I bought this boat a few months ago and discovered it had a bad transom. I am going to fill it in with Seacast, but figured I might as well do this now while I'm at it. I've already hollowed out the inside between the skins. It's got a 15" transom height, but I want to raise it another 5" so...
  4. Y

    1977 Johnson 35 Seahorse starting issues

    Re: 1977 Johnson 35 Seahorse starting issues No I have not checked for spark when it won't start. I will try that tomorrow. My boat is a 15ft runabout and I have the fuel tank in the bow. The bulb is 1.5' from the fuel tank and the remaining ~11' run back to the motor. This wouldn't be an issue...
  5. Y

    1977 Johnson 35 Seahorse starting issues

    1977 Johnson 35hp Seahorse 35EL77C I've had this motor for over a month now and I have been having an issue starting it up. I should re-phrase it, I am having an issue re-starting it after it has been running. From a cold start it starts just fine. No excessive cranking needed to get it started...
See more
Top