Recent content by Yukon Craig

I have an old merc that I just took the carburetor off of and I can't remember the sequencing of choke assembly(brilliant guy that I am lol). There is one clip in particular that looks like it clips into the screw holding the assembly on but I cant figure how it goes. Can anyone help me with...

I recently bought a electronic fuel gauge. It has positive and negative coming off the sender from the tank and additional ground on the gauge itself. I put a fuseable link in it, hit the power, blew a 30amp fuse and now the gauge does not work. Did I fry the gauge? It had no fuse instructions...

Does anyone know what a Honda 30hp four stroke would get for gas mileage or where I could find this out?

I have a lowrance lms 525df. It loses bottom constantly at low or high speeds. Doesn't matter where I put the transducer, how I set up the ping speed or if I set it to 50 or 200khz. I thought it was the transducer so swapped it out and have the same problem. Wired and rewired properly. Any one...

I have a lowrance 525df. I cant find a map from Navionics for the yukon but found one from garmin. I am wondering if a map downloaded from garmin would be compatible with my lowrance?

I have an older 4.5 hp merc. I recently change the impeller and when I reassembled the motor has to held in reverse or it pops out. How can I adjust this so it stays in gear? Thanks YC

I went to replace the impellar and the shifter rod pulled out and I can't reseat it, any help would be appreciated. Thanks.

I have a yamaha f115 2003 four stroke. I was trolling this weekend and my batteries went dead. I have them hooked up to a two way switch which was in the "all" position. I was running a fishfinder and my wipers at times. Would this be enough to drain both batteries or do I possibly have a bigger...