I am sure that this is a simple question, but does anyone know where the mixture screws are for the following carb? (see pic below or https://www.mysticmarinediscounts.com/wp-content/uploads/2014/08/SIE%2076151.jpg ). My Mercruiser 7.4 is running very rich and I need to adjust the mixture...
I have a 26' command bridge with helms in both the cabin and command bridge. I have the standard gauges at both stations but the temperature and oil pressure gauges both are connected to the one and only temperature/oil pressure senders on the engine. As a result the readings on my gauges are...
Good Day,
I am about to install my refurbished Bravo transom shield, complete with a brand new gasket. Mercruiser states that caulking/sealant is not necessary for installation, and there seems to be varying opinions on whether to caulk the outer transom plate or not.
My outer transom is...
Can someone please suggest a thru-hull petcock valve that can be used for emptying holding tank waste? I can boat 3 miles off-shore and therefore a candidate for emptying a holding tank into the ocean. My main question is: Would a clamshell petcock valve work for this waste removal or would...
I recently purchased a 26' Tolly Craft command bridge and the previous owner retro-fitted a 8' by 16" wide gas tank right down the center of the mid-cabin when he repowered the engine. However, he did not install a gas gauge and when I asked him why he mentioned that a gas gauge would never...
Does anyone know of a company in the USA or Canada that can custom make a windshield for a Bayliner Contessa Sunbridge? One of the previous owners retro-fitted a very bizzare looking windsheild and I would like to get it back to it original state.
Thanks
I have an older ('84 I think) Volvo A270 Leg with a stuck propeller cone. I have taken out the center allen-head screw and put many a screw driver through the tool-hole but preceeded to bend everyone of them while trying to unthread this cone.
I am trying to turn this counter-clockwise and it...
