Search results

  1. R

    DT 115 701622 Getting Hot

    Melted temp sensor but pumping water out of indicator. Removed Thermostat to check and plenty of water moving through cavity for thermostat. Please help & Thank You in Advance.
  2. R

    Constant Alarm

    50 mercury 3 cyl. 2-stroke OT045541: overheat alarm stays on and engine is cooling. Any thoughts or help please & thank you in advance
  3. R

    86 evinrude 150 alarm

    E150STLCDC has a new impeller and after 20 to 30 min. of run time the constant alarm goes off. At this point it runs bad. could the vacum switch which is NLA cause this situation. Thanks in advance.
  4. R

    Xl760 impeller housing

    What is the clearance spec for wear in housing between impeller and housing and whats involved in replacing the housing. Unit has a stainless impeller now. Thanks!
  5. R

    Bravo X Transom

    Restriction in water hose that goes to gimbal housing at pickup hose. I pulled off the water hose at inside of transom and removed the 2 bolts that hold hose end on and a pencil will not fit through there because of corrosion and the hose blocking the hole. This does not look like fun. Its an 03...
  6. R

    03 496 ho steady alarm

    Runs cool and anything above 4500 rpm the alarm goes off and it goes into guardian. Brand new sea water assy. Checked water pressure sender and no trash in it.
  7. R

    1990 ve50belesr evinrude 50 fuel problem

    Found the vro pump is not working correctly and it will only idle with choke. The vro pump is 360.00 why would I buy that can someone guide me through manual fuel pump conversion and pre mix
  8. R

    1990 Evinrude 50 hp Wont Idle

    It would not start and the vro siphoned into carbs. Drained carbs and decided that I would look at the fuel in the tank first before I went on. Fuel was dead so I drained the fuel and now I can get the engine to run but it will not idle. Took drains out again in carbs and flushed and added power...
  9. R

    2000 115 Johnson SEI Gearcase Assy

    Found a replacement gearcase assy from sei and it does not come with a vertical driveshaft or a shift shaft. How is this a gearcase assy? I guess 795.00 was too good to be true. What does it take to pull these parts from my exsisting gearcase? Thanks
  10. R

    1973 johnson 85 hp gearcase removal

    How do you get the shift linkage off this to drop the lower unit. need help please
  11. R

    96 sea doo xp oiling problem

    96 sea doo xp would not crank, found cylinders full of oil and alot of it. does anybody have any info on what would cause this and how i go about repairing it. thank you so much for your help
  12. R

    1973 johnson 85 hp trim assy

    Cant find a part # for a trim assembly for a 1973 85 hp johnson. Is it still avail. because the one have is not repairable. I hope someone can help. Thanks
  13. R

    4.3 lx mercruiser

    1994 4.3 v6 mercruiser spark plug # ngk. The engine has the original spark plugs. Im looking for the correct ngk spark plug. I dont have the serial # right now but I do know its OF something and I will get it soon and post it thanks
  14. R

    removing cobra drive

    1987 cobra drive non sx how do you remove the drive as far as the shift cable. should it be in forward gear or not and once the drive is pulled back what goes on with releasing the shift cable any help would be great
  15. R

    Bravo 3 Steering Actuator OM700

    On the parts schematic it shows 2 fittings for the power steering hoses and it looks to me like they are quick disconnects. The boat I am working on doesn't have quick disconnect fittings. The part number I am finding for the steering actuator is 806034A1. Is that the correct part number?? Or...
  16. R

    Cobra Outdrive Plug

    Cobra drive plug in upper gear housing plug on the port side. Somebody thought they were checking gear oil and removed this plug and the fastener fell down in the drive on the inside. What is the best way to repair this? I have seen people epoxy the hole and also a welch plug put in. This plug...
  17. R

    Steering cable bravo

    The boat is 2004 bravo 3 350 mag and the steering is impossible to steer with the engine on or off its just as hard to steer. Removed the steering cable from the accuator and it still tough to steer. After removing the steering cable one of my questions is where do you mesure the cable for the...
  18. R

    2001 115 johnson gearcase removal ?

    how do you get the shift shaft free under vro pump this is the worst i have seen. please help I need to be back in the water soon. It looks like there is a 1/4 20 bolt but that doesnt look like that will get the shaft loose to to drop the lower.
  19. R

    96 mercury 115 control on engine is stiff

    have a 96 mercury 115 with og31 serial # the control box is very stiff with the cables disconnected from engine and it seams like the control on the engine is very stiff. according to the owner of the boat it has been this way since bought the boat. the throttle cable is all the way at the end...
  20. R

    Alarm going off

    engine # p200tlrq impeller was replaced and sensor in engine oil tank was replaced and a sloid alarm goes off and engine is in limp mode. anybody have any suggestions this guy has taken boat to a shop and still has the same problem.
Top