Search results

  1. gergAlicious

    VDO style Rudder Angle sender for Alpha One

    Has anyone here adapted a sender like the one pictured below to an Alpha One?
  2. gergAlicious

    Tracking float side issue for bilge pump

    My bilge pump works with the dash switch. So that side is fine. The float does not operate it however. I have verified the switch at the float is good. I also have 12VDC going into the switch. I disconnect the float wires @ harness and jumper the leads and nothing happens - jumping towards...
  3. gergAlicious

    Block pressure test - questions

    Moderators-please delete if this is an issue, but my last two posts got combined and now the last post link is acting really wonky. ‘Last post’ leads you t the first post of the 8 page thread. Anyhow, is there any acceptable leak down rate in a block pressure test? My block has been under...
  4. gergAlicious

    4.3 mpi

    So does the MPI indicate fuel injection? As is Multiport FI ? I thought I read somewhere that the 4.3MPI took special graphite embedded head gaskets, that you do not spray before installing. All others are sprayed (hi tack - or what ever is spec'd). Does a carburetor engine really take a...
  5. gergAlicious

    2004 Mercruiser Chaparral . . . it happened . . . engine work ahead

    So my job took a turn for the better late in 2016 and I was home pretty much on weekends only long enough to sleep and recharge. Needless to say everything was neglected, even the NEW drain plugs I put in for winterizing the engine the year before. So . . . . exhaust manifolds and at least one...
  6. gergAlicious

    4.3 Rebuild

    So my job took a turn for the better late in 2016 and I was home pretty much on weekends only long enough to sleep and recharge. Needless to say everything was neglected, even the NEW drain plugs I put in for winterizing the engine the year before. So . . . . exhaust manifolds and at least one...
  7. gergAlicious

    2004 Chaparral 4.3 Mercruiser Cooling question

    Thanks Bondo! I read that an open system should have a 143* T-stat? Anyhow, I took a look at a few things just now. I pulled two hoses to verify the check balls weren't open or stuck. They both look fine. Is it strange or bad that the hoses I am pointing at here NEVER get even warm? Nor the...
  8. gergAlicious

    2004 Chaparral 4.3 Mercruiser Cooling question

    I have noticed in the three trips out this year that my cooling gage never really tops ~165* give or take. This is a 19' boat, I run it about 3900 rpm for six or seven miles (repeated route) and when I look at the engine after running, the tanks above the exhaust manifolds aren't even warm. The...
  9. gergAlicious

    Getting my old '58 Feather Craft back

    Hi all, just wanted to introduce myself and post up about my '57 Feather Craft Vagabond II (I believe). I got the boat years ago from my dad's uncle, after my grandfather's funeral. It had a '59 Lark 35 on it and ran like a top. I didn't have the funds to do much with it at the time. A...
Top