Search results

  1. 2

    SX-M vs SX-MHP Transom Assembly

    I have a TSK SX-M transom assembly (sn 4111636204) from a 2000 Four Winns with 5.0GL engine. I bought the boat cheap after one of the drive shaft u-joints and engine coupler decided to "leave the chat". When it let go, the u-joint rattled around and damaged the drive bellows mounting area, not...
  2. 2

    Evinrude 15HP Lower Unit Pinion Gear Bearing Replacement

    I have a 1996 Evinrude E15REDS outboard. I had a bad shift shaft seal, water got in the lower unit and it sat long enough to rust the bearings. I can replace the forward gear tapered bearing, the reverse gear needle bearing, the prop shaft needle bearing, and the upper driveshaft needle...
  3. 2

    SX U-Joint Bellows Full of Gear Oil

    I have a Volvo Penta SX outdrive from the OMC transition era (1998). I removed the drive and found the U-Joint bellows with a lot of gear oil inside. I've ordered a upper housing seal kit and a new crush spacer. I know I have to re-set pinion bearing rolling torque after replacing the input...
  4. 2

    Johnson 9.9 Won't Rev Up (ignition?)

    I have a 1992 Johnson J10RENA. I've been through just about everything I can think of on this motor (except the ignition.) It will start and idle like a limo all day long. Great for trolling. It just won't rev beyond ~1500 rpm, even at WOT. It just kinda bogs and stumbles. The carb is...
  5. 2

    1991 XR4 150 Hesitates on Acceleration

    1991 XR4 150 (s/n 0D015295). When I “punch it” from part throttle to full throttle, it hesitates for a little, then takes off and runs fine. I’ve just rebuilt the carbs with new gaskets, and everything looked very clean. Unfortunately, the accelerator pump rubber part was not included in the...
  6. 2

    Hynautic Hydraulics--Help Needed

    Not new to boating, but this is my first hydraulic steering system. Hynautic H82 Helm with K6 cylinder on a 1991 Merc 150XR4 outboard. The system seems "notchy" and doesn't work very well. Many turns of the wheel to get any steering action. I've done several cable steering systems, rebuilt...
  7. 2

    Online OEM Parts Source

    I've done my best to turn the web upside-down to find an online discount supplier of OEM Mercury outboard parts, but have come up pretty empty. Iboats has good selection/pricing on aftermarket stuff (Sierra, etc.), but not OEM parts. Any thoughts?? I previously owned a Yamaha and found...
  8. 2

    1991 150 XR4 Tell-Tale Stream

    I just bought a boat with an XR4 150 outboard. I have a question regarding the "proper" operation of the tell-tale water discharge. The Yamaha's I've owned in the past immediately started pumping water from the tell-tale when the engine was started. It was discharged from the bottom of the...
  9. 2

    150 XR2 XR4 XR6 Differences

    I'm looking at buying a used boat with a 1991 150 XR4 Merc. Please help educate me as to what the XR2, XR4, XR6 designations mean on the late 80's and 1990's model Merc 150's. Thanks. Terry
Top