Search results

  1. N

    johnson motor in an evinrude body

    Hi.Wanted to know if a 1958 7.5 hp johnson would drop straight into a 57 7.5hp evinrude body?Are these motors identical?Thanks for the info.
  2. N

    Old Johnson's

    Hi.I have a couple of old Johnson motors.One is a 1972 85hp Hydro-Electric and the other is a 1968 65hp Electric.I did a search for some posts on these motors and I get the opinion that they are to be avoided because of the electric shift lower units.A mechanic at a local marina said he would'nt...
  3. N

    1972 85hp Johnson Locked Up

    Hi.I have a 1972 85hp Johnson that has been sitting for a long time and I am trying to free it up.I soaked the cylinders with penetrating oil a few times over the past few weeks and tried to get it to turn over by using a breaker bar on the flywheel nut but no go.I was wanting to know if this...
  4. N

    Do I have a bad coil?

    Hello.I have a 1985 15hp Yamaha SK motor.I just got through putting in new rings and pistons and rebuilding the carb.I have good compression and good fuel delivery.I started the motor and noticed water leaking out the head gasket so I shut it off and removed the head and cleaned both surfaces...
  5. N

    1985 15hp Yamaha no water out of tell tale

    Hi.I have a 15hp Yamaha that runs good but has no water spitting out of the tell tale.I pulled apart the lower unit and checked the water pump impeller and it is fine.I also checked the thermostat and ran it without it installed and still no water.I ran some stiff wire up the tell tale hole but...
  6. N

    1957 Evinrude with a broken connecting rod

    Hi.I have a 57 Evinrude 7.5hp with a broken connecting rod.I did a search but could not find a source for parts.Can anyone tell me if internal engine parts are available for this motor or is it now only good for parts?Thanks.
  7. N

    59 Lark parts on a 63 Evinrude

    Hi.Wanted to know if a starter,solenoid and bracket and a flywheel from a 1959 Lark 35hp would fit on a 1963 Evinrude 28hp.Thanks.
Top