Search results

  1. D

    92 70HP Johnson FLOAT SETTING ??

    I am going to install rebuild kits in my 1992 70HP Johnson. How do I set float level? Anything else I should know about? The carbs are the early style.
  2. D

    JOHNSON 1992 70 HP, Stuck needle valve?

    My 1992 Johnson 70hp has a major fuel problem. When I pump the bulb it never get hard, I replaced the fuel lines and bulb with double clamps where posible. no help. If I continue to pump the bulb the lower cylinder will fill with fuel. I suspect a bad needle valve, before I get into puting in a...
  3. D

    Johnson 1992 70 Hp Vro, Fuel Line Leak?

    I started the season out by replacing the weathered fuel line and primer bulb. Then the problems started. The new bulb and line were clamped with screw type hose clamps, the primer bulb would not pump up hard like the old one, lots of smoke with high oil consumption, and surging RPM at mid...
  4. D

    70 HP Johnson removing oil sending unit ?

    Last week-end I stated to get a no oil warning horn. the tank was 5/8 full, the primer bulb was hard, and had plenty of exaust smoke. Turning engine off and on would stop the horn sometimes but only for 5 - 10 min. I could not easly remove the sending unit from the oil tank without force to...
  5. D

    Transom bolt holes ?

    Can someone save me a 200 mile trip ? I need to make a support plate for my transom and I don't have the measurement of the bolt spacing. The motor is a 1992 Johnson 70 HP. I need the distance between the bolt centers and from the top edge of the transom to the bolt center. Also are the bolts...
Top