Search results

  1. T

    1960 Evinrude Lark 40 hp wiring harness connect

    I am rebuilding my harness and it seems the connector is molded and not reusable. If so, what have others done for replacing the connector? Here is a link to a couple photos. http://www.flickr.com/photos/26174388@N06/ Thanks Joseph
  2. T

    1960 Evinrude Lark 40 hp wiring harness

    I am rebuilding my harness is falling apart and somewhat deformed from age and needed to know what size wires these are in the harness. Thanks
  3. T

    where to buy stainless screws

    i am looking to replace the screws on my 1960 40hp evinrude. where is a good place to find and buy them? thanks!!!
  4. T

    Old Screws

    I am replacing seals and gaskets on the lower unit. There have been several screws twist off at the head and I need to order new ones. My question is should I replace all the screws and where is the best place to buy them? I have an 1960 Evinrude Lark 40 hp. Thanks.
  5. T

    removing drive shaft seal from lower unit

    how do you remove the drive shaft seal where the drive shaft enters the lower unit? i have a 1960 evinrude lark 40 hp. thanks
  6. T

    1960 40 hp Lark lower unit stuck

    I am new and my uncle gave me an old boat and I am going to clean her up, replace seals and gaskets etc in lower unit. i am trying to remove the lower unit and it appears that the drive shaft will not come loose. the lower unit has come down about an inch, but will not come loose. I have been...
Top