Search results

  1. M

    No Spark in Lower Cylinder.. please help

    Hey guys, I am not getting spark in my lower cylinder. I replaced the coil and still no spark. I then checked the voltage going to the powerpack and there is no voltage coming from the stator for the lower cylinder but the wires going to the upper cylinder have a voltage and the top cylinder is...
  2. M

    1980 evinrude 35hp compression

    Hey guys, I did a compression test on my motor today. Is it normal to take 10 seconds to reach max reading? Also should it hold that number on the gauge once you stop cranking? When I stopped cranking the numbers slowly dropped.I got 120 in both cylinders is this close to factory specs? Thanks...
  3. M

    Evinrude Regulator Question

    Hello I have a 1980 35hp evinrude with electric start. Does anyone know if there Is a voltage regulator on this motor? I measured the voltage and as I increased the rpm the output exceeded 20V! Im afraid to hook up my battery to it because i believe this voltage is way too high. Is this normal...
  4. M

    Starter Solenoid HEEELP!

    I just bought an 1980 Evinrude 35hp motor with electric start. the motor didnt come with the ignition but i do have the plug that plugs into the motor for electric start. I also measured the voltage with the motor running and the voltage rises as you increase the Rpm. The voltage exceeds 20V...
  5. M

    1980 Evinrude 35hp electric start question

    I believe its a 1980 evinrude (E35ECSM). Does anyone have the pinout for the plug that connects to the battery and then plugs into the motor for electric start? Thanks
  6. M

    1970 Evinrude fastwin Throttle Cable

    Does anyone Know where I can get a new/used 1970 Evinrude Fastwin throttle cable? Thanks
  7. M

    1970 Evinrude Fastwin Fuel pump

    Hello I am losing prime on my gas line while the motor is running and thus the motor will stall. If i prime the ball the motor will recover. The fuel pump is fairly new and appears to be working fine. What should I look for when inspecting the pump to verify this is the problem?Thanks.
  8. M

    18hp fastwin lower end help

    Hello everyone. I have a small leak from my prop seal and water is getting into the lower end of my motor. Correct me if im wrong but I believe the gasket kit i need is (18-2684). I am new to outboard repair but I am good with my hands and following directions. Can anyone give me detailed...
  9. M

    Evinrude Fastwin Help

    Hello everyone I have a few problems with my motor. I believe its a 1970 18hp fastwin. (18002E). I have a few issues so I am just going to list all of them. First off after running for a bit the gas line loses prime and the motor will stall. I am running a 50:1 mix .Second there is ALOT of oil...
Top