Search results

  1. S

    need help with tilt and trim wiring

    recently a wire broke loose on my tilt and trim switch on the control handle. I re-attached the wire to the switch and nothing happened. so i thought maybe i had damaged the switch when i soldered the wires back on it. I replace the switch and still got nothing. the t/t switch on the motor...
  2. S

    1990 48 SPL carb question

    i have a 1990 48 spl runs good except for at low/idle speed. I can start and let warm up drop the idle lever down and within 5 seconds the motor chokes off. I rebuilt the carbs (completly) setting floats parallel with bowl. Am I missing something? I'm under the assumption my high and low...
  3. S

    '89 48 hp spl lower unit seal replacement

    Good evening everyone. I intend on installing a new water pump and lower unit seal kit on my 48 spl. I have ordered a manual for the motor but I would like to get started by dropping the lower unit while I wait for the manual. If there is a step by step procedure that I could be given until...
  4. S

    High Idle Lever Adjustment

    I have read in several previous posts about the high idle lever becoming loose and not working properly. In my situation the lever goes up and down with tention (but not stiff) in both directions but it doesn't seem to move the trottle very much. I just bought the boat and motor (48sles) and...
  5. S

    Evinrude 40hp carb problems?

    Hey guys! This is my first post. I know I should wait until I have all my facts straight, but it may be a problem thats the same no matter what the year. I have a 40 hp Evinrude from the early 90's on an 18' alumaweld boat and it will not push it like it should. It runs good at idol, but I...
Top