Search results

  1. recka81

    Trouble restarting Evinrude after running

    My 1973 65hp Evinrude Triumph starts and runs perfectly when first out. However, once warm, it has a lot of trouble restarting. Specifically, if when I restart the motor, if I don’t immediately give it some throttle, it will sputter out, die, and have a lot of trouble restarting. Just turns over...
  2. recka81

    Help with boat trailer hub!!

    I have a 16' Starcraft SS that's on an old sing axle dilly trailer (early 70's). One of my lug nuts got stuck on the lug and the lug stripped completely. Long story short, I need to replace the hub. I found a 4 lug hub at tractor supply (pictured) and installed but found that there was WAY...
  3. recka81

    Torque amount for flywheel nut - 65HP Evinrude

    Does anyone know the proper torque amount for the flywheel nut on a '73 Evinrude 65HP engine? Model number is 65373R. I paid a guy to install a new stator but he used an impact wrench to reinstall the flywheel nut, which I think is improper. Also, do I need a spanner wrench (or something...
  4. recka81

    '73 Evinrude 65HP Triumph trouble RE-starting - stator issue?

    I posted a while back (couldn't find original thread) about a strange issue I am having with my '73 Evinrude Triumph (65373R). The boat starts and runs perfectly. However, after idling for a long time or after letting it sit after running hard, it will sometimes cut out and then have trouble...
  5. recka81

    Help with temp gauge on '73 Evinrude 65HP

    These old 65hp Evinrude Triumphs do not have a tell tale (and I don't want to drill into the water jacket) so I want to install a temp gauge. I saw a video on installing the sending unit in a pre-threaded "blind" hole near the head. Does anyone know where I can put the temperature sending unit...
  6. recka81

    Starcraft SS16 Floor Repair Help

    Starcraft SS16 floor repair Got tired of a soft spot in my floor and started ripping it up. I wanted to know if I could replace just a section of the floor rather than ripping it all up or do I need to do the entire thing? Finally, how do I remove that brown side paneling so I can get to the...
  7. recka81

    Foam in early 70's Starcraft

    I have an early 70's 16 ft StarCraft. I want to install a bilge bump in the rear but to create an ejection port, I need to go through some of the foam on the side. That got me wondering, is any of this foam in the back of the boat necessary or can I just remove it for good? Does this foam...
  8. recka81

    Removing transom clamp from '73 Evinrude - 65HP

    Hello, I have a 65hp 1973 Evinrude Triumph that runs perfectly ... until I broke one side of the transom bracket! I have a new bracket (actually I have the entire swivel mount with both brackets) but cannot figure out how to remove this from the boat without taking the power head off and...
Top