The nipple on the vacuum switch and bracket on my johnson gt 150 broke and I am looking for a replacement part but everywhere I have searched says that it is obsolete. Do I need this on the motor or can I just take it off? Also if I do need it does anyone know where I might find one?
The nipple on the vacuum switch and bracket on my johnson gt 150 broke and I am looking for a replacement part but everywhere I have searched says that it is obsolete. Do I need this on the motor or can I just take it off? Also if I do need it does anyone know where I might find one?
I have an 89 Force 150 that runs and puts out water through the 2 holes but after it runs for about 3-4 minutes it stops putting out water and shuts off. If I let it sit a while then try to restart it will run for a while and shut down again. Would this be the impellar or would it be the...
I am in need of a new prop for my 89 force 150. After trying to find the prop size of the current prop I am not able to locate any numbers on the prop except DIA 12 5/8 X 2id. I am not able to locate the pitch of the current prop. Would anyone happen to know what the orginal prop size and...
Took the boat to the lake this morning put her in battery was dead. Charged the battery put back in water started right up. Go boat loaded to go fishing idled good did some circles by the marina to see how motor was running before I took off across the lake. Evey thing seemed fine took off...
I have a motorguide trolling motor and when I use it it runs for a bit then cuts off, then if I let it sit for a few minutes it starts working again then cuts off again. It runs like this all the time. It is a new trolling motor that I bought off of ebay. Is there something wrong with the...
Hello,
Did a compression test on 89 force 150 #1=120, #2=110, #3 120, #4=120, #5=120.
Can some please let me know if these numbers are good for this motor. I would greatly appreciate.
Thanks
New to forum
Removed the head from my 89 Force 150 and have water in the lower 2 cylinders the head gasket on the second to last cylinder was broken would this allow water to drain into the bottom cylinder. Also don't know the torque for the head but seemed that the bolts that hold it on were...
