Search results

  1. Faztbullet

    No power to trim or motor

    Do you have a battery switch? If so look for loose connections
  2. Faztbullet

    93 manier 75 hp

    No its #38
  3. Faztbullet

    1998 Evinrude 90 SPL WORTH

    Sounds like whoever rebuilt it did not fix the original problem of why it failed the first time...$300-400 at best
  4. Faztbullet

    1985 Johnson 150 idle surge

    Ignition problem.. start by disconnecting the harness and then jump starter. If it runs OK the problem boat side. Also you will need primer on to kill it or rags stuffed into carbs if you do this. Check the voltage from stator to packs and if you bought a CDI brand timer check Amphenol pins in...
  5. Faztbullet

    Problem removing Water Pump base on 50hp outboard

    Well your going to need a new one first. Then apply 10psi air into unit, use 2 coated decking screw 3.5 inches long, thread into base and use 2 cats paw pry bar and pull up on it evenly
  6. Faztbullet

    No shut off

    Could be missing gound on blk wire at switch also
  7. Faztbullet

    1992 Evinrude 150 aluminum in cylinder

    What a hack video!!!! There is no way to wash out honing debris from cylinder ports and crankshaft area. Those new pistons are now worthless. I'll bet motor did run more than 10 hrs before it failed again
  8. Faztbullet

    1992 Evinrude 150 aluminum in cylinder

    Do not rebuild it till the block is sent to be pressure tested. The early models are bad about water leaks into cylinders from factory glue lines especially #1. The sleeves can be pulled a welded and re-sleeved but not worth it as 91 is a year all to itself, 92-93 are all to themselves.
  9. Faztbullet

    1986 Mariner 40HP 6E9 Throttle Cable Type Help

    Need the 630 type..... https://www.westmarine.com/sierra-6--630-type-standard-control-cable-for-mariner-40-hp-or-less-pre-1993-with-mariner-mercury-controls-6537054.html?srsltid=AfmBOordhUbdqDnkkUxOiiImUMEjoewWWelzulV6rFBpy70A8il1EV8z56Y
  10. Faztbullet

    Bottom cylinder sounds bad 1997 evinrude 3 cylinder

    You know how index? Bring each cylinder to TDC and mark on flywheel at timing pointer. The take timing lite and check each cylinder to see if it is firing at correct time. They will be a few degrees off from mark but if you see a big difference. Its not magnets as if hub slipped all cylinders...
  11. Faztbullet

    2000 - 225 Evinrude Fitch EMM Question

    The "3 finger salute " is a internal EMM problem, need to send off for repair
  12. Faztbullet

    1989 Evinrude 150xp Temp Gauge, Starboard Temp Switch, Fast Idle & Forward to Neutral Shifting

    You need to revisit shop
  13. Faztbullet

    Bottom cylinder sounds bad 1997 evinrude 3 cylinder

    Indexing tells you if cylinders is firing at the correct time.
  14. Faztbullet

    Frankenstein engine build

    Sadly both Land & Sea performance and Second Effort have closed
  15. Faztbullet

    Frankenstein engine build

    These was offered years ago and hard to find. Second Effort may have offered it for a 3 cylinder, but the only kits I have seen in person was a Land & Sea was a 12 pack for a V-6. They also offered a kit for the 2 cylinder 50/60 HP for a 2 barrel mod. Why a "screamer" and what type of boat?
  16. Faztbullet

    Spark plugs for 60hp 2 stroke

    NGK-BUZHW if you positive its a 1991
  17. Faztbullet

    Frankenstein engine build

    Bovine scat someone posted
  18. Faztbullet

    Bottom cylinder sounds bad 1997 evinrude 3 cylinder

    Index the flywheel and check #3 for intermittent spark. Swap the coils as they are a pressed powder core and easily broken from overtightening. This can cause coil to intermittent or double fire. If still intermittent place meter inline and see if DVA voltage is low when coil is attached.
  19. Faztbullet

    Mercury 25 HP EFI OR106999 & Up Fuel Problem

    ECU fuel driver problem
  20. Faztbullet

    Starts and idles fine, but cannot get full speed (1985 Johnson 140 hp - J140TLCO)

    Modified as in how and what?
Top