Search results

  1. lmbr

    150 Hp 2 stroke Optimax will not run at low idle.

    Just recently got this one. Will start and run at fast idle but when I reduce it, it dies. Had a mechanic tell me that a Optimax will do that but it has a part to allow it to keep running. Any help sure would be appreciated. It is a 2011 model 150 Optimax.
  2. lmbr

    1990 90 hp Mercury. Beeping when key turned on.

    This is a project boat. Been sitting for a few years. Will start but not stay running. Thinking carb kits. However the biggest problem is a beeping when the key is turned on. I’m thinking low oil alarm but there is oil in the tank. Am I on the right track? Should I remove the tank, dump the old...
  3. lmbr

    Shift problems, 2004 50 hp EFI

    Shifting is stiff, especially when going into reverse. With cables disconnected from the engine, they are easy to move. Manually shifting with the cables disconnected is pretty stiff and I guessing that is why when they are connected shifting is so difficult. Sometimes when shifting into reverse...
  4. lmbr

    84 60 hp Johnson no spark

    Have been restoring this motor. (Sat idle for 3 years) After cleaning and rebuilding carbs, cleaned the entire fuel system and replacing power pack it started and ran good but no tell tale. Went thru lengthy process of replacing water pump impeller, changed thermostat, serviced pressure relief...
  5. lmbr

    84 60 hp Johnson cooling system problem

    84 Johnson 60 hp restoring. Compression on both cylinders is 115 - 120. After overhauling carbs and completely cleaning fuel system engine started right up. But when I started the motor, there was no Tell Tale so I overhauled the water pump and replaced the impeller. I am using earmuffs. When I...
  6. lmbr

    Restoring a 1984 Johnson J60ELCRE 60hp

    Have this 1984 60 hp that has been sitting for 3 years. Everything seems to be working OK up to the carbs. (Compression is 125 psi on both cylinders.) Both carbs are type IV (?) and are not adjustable. Not all of the nozzles are in place so I have ordered new ones. Problem, one of the high speed...
  7. lmbr

    84 60 hp Johnson carb overhaul

    This motor has been sitting up for 3 years and I want to get running again. Pretty sure the carbs need cleaning, etc. Is there a good place to get the cleaning / overhaul procedure?
  8. lmbr

    2002 Nissan 50 TLDI over revs and slows down when trimmed up past center.

    Service tech said from cavitation but this started about a year ago and getting worse. When I lower the motor it stops. Recently installed a Humminbird hi def transducer. Previously had a standard compact ducer. Would that cause that? Before the compact ducer I had a DI ducer and don't remember...
  9. lmbr

    Bow Eye Replacement Aluminum boat

    I broke the bow eye on my Aluminum Tracker boat. What can I use to replace it and not face electrolysis?
  10. lmbr

    94 Tracker Pro 17 wiring diagram

    I am redoing a 94 Tracker Pro 17 and need to work on the wiring. A wiring diagram would be a great help. Also any suggestions on how to get the wiring from the back of the boat to the console would also be good The screws holding the interior covers over the wiring are in bad shape & I cannot...
  11. lmbr

    1984 60hp Johnson will not turn off.

    My 1984 Johnson 60 hp runs great. Problem is when I turn the key off it won't stop. Putt the emergency stop, still won't stop. Checked the key switch wiring all OK. The red black wire has 12 V when key is on, 0 V when off. I believe this is what it is supposed to be. Only way I can stop it is by...
  12. lmbr

    Steering backward

    I just replaced the rack and pinion steering cable on my boat. Now it steers opposite of what it should. What did I do wrong? I don't know the correct names for all the parts. I replaced the cable with the rectangle on the end. I'm assuming that is the rack. They also sent a new hub the steering...
  13. lmbr

    Trottle up problem on 84 60hp

    I have been working on this engine for a while and finally have it running really well except for 1 minor problem. After the engine is warmed up and been running for a while (it really runs very well) and I return to idle or stop, when I throttle back up I have to do so gradually or it bogs...
  14. lmbr

    84 Johnstartson 60 hp strted and ran good then went downhill

    Motor started and ran good for 5 min then started missing. Ran good intermittantly finished barely running at full throttle. Will start and run so so in neutral with warm up lever. Just filled up prior to using. Have replaced fuel pump and fuel line and bulb. Rebuilt carbs a couple of months ago.
  15. lmbr

    Adjusting remote control cables

    I am replacing my remote control box and cables on my 84 Johnson 60 hp. Any suggestions as to how to adjust the length. Using the old cables for their length is not an option.
  16. lmbr

    remove 84 Johnson motor from boat

    I hit a stump and put a hole in my hull. I want to remove the 84 Johnson motor so I can turn the hull over for the repair. (I am not sure I can do this but it seems the best way to access the repair.) The motor has power trim and a rack and pinion steering system. It looks like the motor and...
  17. lmbr

    60 hp Johnson starts (rough) will not keep running.

    Just bought this boat and motor used and first time out it ran great. Problem was I ran out of fuel about 4 miles from ramp. Got about a gallon from passerby and nearly made the ramp before running out again. (Dumb me) Now the motor will start after squeezing primer ball but will not keep...
Top