Search results

  1. S

    2000 Johnson 15hp wont pump water

    Ask your repair guys if the pulled the powerhead from the mid-section...nobody would if they thought the draw tube was okay. It really can't be anything else other than a crack somewhere and it would be burning water or leaking it. That's my 2 cents
  2. S

    84 Evinrude bogging full throttle surge

    Rmillis, Just a shot in the dark here. When you worked under the flywheel installing coil and such, did you use the omc alignment tool? Those have to be set just right for flywheel clearance.
  3. S

    2000 Johnson 15hp wont pump water

    The only other thing it could be is the draw tube has a hole in it or the grommet at the top has failed. Powerhead would have to come off to verify unless someone else has a trick that I don't know of.
  4. S

    1995 Johnson 70hp starts then dies

    Just throwing this out there. VRO, most people back when I had one anyway would just plug off the oil line and then run 50 to 1 in the tank. In fact omc included the plug. People are now installing regular pumps because they are much cheaper and because they don't trust the vro's. What I don't...
  5. S

    No helm power - 2018 Yamaha 704 w/ 2021 F150LB 4 stroke

    Yes, I have the auto circuit breaker going to the dash or main positive bus bar. Every three years or so I have to cut them out because they get all corroded up. My harness failed twice. Right where it goes into the motor because of the steering action going back and forth. 1st time while...
  6. S

    Compression Test without a battery?

    I have a remote starter as well and I put one clip to + battery and the other clip where the signal wire comes from the harness. As far as the impact, while I've never done it, I see people doing it online and with all the spark plugs out I can't see a reason to not do it but with three negative...
  7. S

    Compression Test without a battery?

    You could use an air impact gun on the flywheel nut.
  8. S

    No helm power - 2018 Yamaha 704 w/ 2021 F150LB 4 stroke

    This may sound stupid but do you have super clean battery connections? I recently had problems at my trim and tilt. When I tested power at the engine I had 12.7 volts so I figured must be t&t relay or worse. Messed around for two days before I tried to start it. No start. Put my meter back on...
  9. S

    1995 Johnson 70hp starts then dies

    What do the spark plugs look like after the no start happens?
  10. S

    1995 Johnson 70hp starts then dies

    Did the motor sit with fuel in it for a long time? Sounds like the vro was removed?
  11. S

    Yamaha 100 hp 2000s flywheel locked up

    Not from where I'm from.
  12. S

    Yamaha 100 hp 2000s flywheel locked up

    Overall what he is saying doesn't make sense. Here is what happens. If the gearcase is not removed periodically and greased, the driveshaft gets stuck in the bottom of the powerhead (crankshaft). Usually means the motor becomes a parts motor. Flywheel or oil pump has nothing to do with it.
  13. S

    1996 - Johnson Outboard - Difficulties Starting But Runs Great

    Here is a newer one.
  14. S

    1996 - Johnson Outboard - Difficulties Starting But Runs Great

    Pretty worn but I can see it though. Right now your at the shift position. See the arrows on each side of the small circle? Next larger circle is the start circle. Represents a pull cord. International symbols instead of words. That is where the throttle should be especially when cold. Turn it...
  15. S

    1996 - Johnson Outboard - Difficulties Starting But Runs Great

    Not sure about step 1. Do you have a start position on your tiller? I would swap 3 for 2. 90 is low but I've seen them run that low.
  16. S

    1996 - Johnson Outboard - Difficulties Starting But Runs Great

    Yes, primer ball is on the fuel line. Some motors had a manual primer inside the motor instead of a choke....your does not. Like flyingscott says to much info may be messing you up. In my opinion, if it's idling good and running through out the rpm range than it's not the float. Sounds like your...
  17. S

    1979 Evinrude 55 hp 55975C alarm horn from the controls..

    Tell tale only means it's pumping motor can still overheat. Could be stat, could be plugged passage ways, could be bad sensor. Easiest way is shoot the head with a thermal gun.
  18. S

    Yamaha C60 knocking noise at higher revs

    Did you run it without the cowl? Check to see if anything is hitting the flywheel. Otherwise I guess I would pull the gearcase and see if anything looks wrong with the pump or shift linkage. What does it do at WOT?
  19. S

    1995 Evinrude E40ELEO RPMs

    Didn't you try it already?
  20. S

    1995 Evinrude E40ELEO RPMs

    https://www.marineengine.com/parts/johnson-evinrude-accessories/index.php?year=1995&model=Instruments+1995&section=Tachometer+Kit+-+Flush+Mount+-+7000+Rpm+-+Non-plug-in&yid=34056&mid=34059&sid=38916
Top