Search results

  1. alldodge

    Beeping

    Thanks I'm not finding a soft alarm (2 beeps a minute) on your motor. Is the beep like 2 a minute, or is it erratic and not a steady beeps?
  2. alldodge

    Beeping

    What is your serial number?
  3. alldodge

    Need Help Installing Distributor in 4.3MPI

    Should point to the 8 after install. Don't pay any attention to the other notch
  4. alldodge

    wncmarinesalesinc.com

    Manta shows they started in 1981 and incorporated in NC. Annual revenue of $10M a year. Shows A+ with BBB but there are no reviews. Don't think I would worry about buying from them https://www.manta.com/c/mmz9hd4/wnc-marine-sales-inc
  5. alldodge

    5.0GL - No Power at Coil

    That's a clamp which holds the dizzy but is not put of. Should be able to move once loosened.
  6. alldodge

    Overweight motor

    Or bolt on a 100hp 2 stroke
  7. alldodge

    Overweight motor

    That's the main problem IMO
  8. alldodge

    5.0GL - No Power at Coil

    The cap doesn't look bad to me, but looks can be deceiving. Cap and rotor would be a good thing
  9. alldodge

    5.0GL - No Power at Coil

    Use a white grease pencil or bad of white paint on the notch. Adjust timing light for 8BTDC and let it line up with the pointer. With that kind of rust you must be in salt water
  10. alldodge

    Second Happiest Day . . .

    Sounds like fun, your just to far away for me
  11. alldodge

    Winterizing Question

    Looking at the motor , bottom right should come from the drive
  12. alldodge

    Second Happiest Day . . .

    Hey found this trailer on OSO but will be in FL. Larger then needed and is also goose neck https://www.offshoreonly.com/forums/formula/373557-400-ss-trailer-sale.html
  13. alldodge

    Ford 302 issues

    Very bad to turn the motor over using the crank bolt. It can snap Sounds like your lifters are collapsing, and if that's what's happening they need to be rebuilt or replaced. Probably replaced
  14. alldodge

    5.0GL - No Power at Coil

    I thought of that early on Kenny but since it was a GL figured it had to be electronic, and he found 8V at the 10 pin. Also looked up the serial number 4110185712 and it shows electronic What is weird is he shows a EST dizzy cap and that won't fit
  15. alldodge

    5.0GL - No Power at Coil

    Take a piece of sand paper to it. Then bump the starter as brief as possible to see if something comes up
  16. alldodge

    5.0GL - No Power at Coil

    Kenny is the guy that knows VP For having just a notch you need to look at the balancer for a larger mark followed by some smaller ones. Having an advance timing light, need to set the light for 8 BTDC (assuming that is correct timing for the motor). With motor running the point in your pic...
  17. alldodge

    5.0GL - No Power at Coil

    Timing is easy for your motor. Mark the crankshaft balancer with white grease marker if needed so it can be seen better. Do not have to, sometimes it makes it easier to see. Slightly loosen the distributor just enough so it can be rotated. The motor needs to be warmed up and idling at the...
  18. alldodge

    Winterizing Question

    Start the motor without muffs can damage the impeller The motor is never completely full once motor stops. Even a full ON hose will not supply as much water as the impeller can move
  19. alldodge

    5.0GL - No Power at Coil

    The coil needs 12V when starting and running. Getting only 8V at the connector means there is corrosion and could be on both sides of the connector. You could run 12V from the Bat without an issue While lower voltage can cause the hesitation, there would also be an issue at WOT. Your issue...
  20. alldodge

    Fuel pump fault

    I try to stay away from Sierra but relay should be no issue https://www.ebay.com/itm/123481681712
Top