Search results

  1. Faztbullet

    Issues with a 2003 225 EFI power head that replaced a 2001 225 Optimax.

    Did you swap whole powerhead or just block and swapped parts?
  2. Faztbullet

    Service Manual 1984 90 HP Mercury

    You need this one...
  3. Faztbullet

    1988 20 hp Mariner (NO Spark)

    Disconnect the blk/well at pack and test, if spark wiring issue. No spark ignition issue.
  4. Faztbullet

    1988 20 hp Mariner (NO Spark)

    This has nothing to do with ignition. The switchboxes on these have a high failure rate
  5. Faztbullet

    Mercury 150 xr2 bored .040

    Just go up 2 sizes on mains and down one on idle. Surface heads just enough to make flat or use newer "top hat" heads.
  6. Faztbullet

    Evinrude 40hp Water Temp alarm

    T-stat/poppet is sticking open
  7. Faztbullet

    Alpha 1 Gen 2 limit switch bracket

    Tis normal as the newer senders have a denser material and lil harder to compress
  8. Faztbullet

    Help

    Like I said.....
  9. Faztbullet

    Help

    A 398-5454A16 and up are all 16amp stators and same thickness, the A at end of part number is a series number. So a 398-5454A16 and up will replace it,as the A32 and A 35 are same thinkness.
  10. Faztbullet

    Mercury 150 xr2 bored .040

    Need to find the problem that caused the damage or it will happen again Which cylinders was damaged?
  11. Faztbullet

    1991 75hp L.U swap to 1994 115 work?

    Gear ratio is different, as long as you dont pull skiers or tubes you can play with prop pitches to regain lost RPM
  12. Faztbullet

    2009 Evinrude 130hp G1 lower unit

    It is not a V-6 gearcase but a V-6 housing as gear ratio is different. Put the SEI old style V-4 unit on it and you wont have to change props
  13. Faztbullet

    2022 60 Merc Command Thrust Prop Click Question

    Normal as reverse is non racheting
  14. Faztbullet

    2009 Evinrude 130hp G1 lower unit

    Agree as the ole "batwing " unit wasnt very good. I would suggest he get a SEI unit and plop in driveshaft and go.
  15. Faztbullet

    1978 Johnson 85 HP Choke Issues

    If the tie is holding the choke position open the solenoid will not pull choke plunger down. It will only wiggle when activated
  16. Faztbullet

    1978 Johnson 85 HP Choke Issues

    First you need to lose the homemade clip-on choke and install correct keeper o-ring. The reason choke won't work is wire tie on cable below solenoid has flaps locked open.
  17. Faztbullet

    Best replacement point sets available

    EMP brand...made it Italy 300-02882
  18. Faztbullet

    2000 Johnson 50 Cylinder Damage. Help!

    Those are water droplets from leaking head gasket or water in fuel or oil tank
Top