Search results

  1. R

    Motor surges

    89 yamaha 150etlf. Motor surges when at 3/4 to full throttle had the diaphrams replaced and its still doing it. Also reverse gear grinds really bad when coming out of neutral. Any ideas?
  2. R

    tilt trim problem 89 yamaha

    Tilt and trim is inop it will only make a clicking noise when you try to operate it. Has fluid,. Any suggestions as to what else to check before I take it in. Help is appreciated.
  3. R

    89 yamaha 150

    Motor at 3/4 to full speed runs fine but occationally hesitates a little. Plugs where changed about 6 months ago, carb restriction? How hard is it to clean the carbs and is this a do it yourself job?
  4. R

    Trim?

    My 89 yamaha 150 will not trim in or out had leak repaired about 8 months ago. Ran boat since and its run fine up until yesterday I checked it and it has fluid, I can hear clicking in the control relay box any suggestions?
  5. R

    Motor Setting info

    I have a 20ft tunnel hull bay boat. The motor has a shallow blaster cavitational plate. I was wondering how the motor should be set as far as into the water. Havent had a chance to mess with it much.
  6. R

    deck question

    can I convert and if so how hard is it to do? 20 ft tunnel hull boat with sides to a flat deck?
  7. R

    Spun Hub

    What is involved in repairing a spun hub on the prop, need to repair my yamaha 150 and was wondering if this is somthing I can do or does it need to be taken to a marine shop for machining or etc.
  8. R

    Prop?

    Took my boat out this past weekend, noticed that the boat runs fine until accelerated, the boat engine would rev up high but it felt like the prop wasn't turning. The mech I called wasnt to specific to what it was he just told me something had to be re-done inside. Can anyone give me a more...
  9. R

    89 yamaha 150 ETLF ?

    I have been trying to get my boat going for a few months now. Problem started when I didnt notice a crack in the oil resevoir, so i got some rain in the tank. Cleaned out the tank new oil, empty cups on the carbs and changed water seperator, still not running very well I took it to a local mech...
  10. R

    89 yamaha 150hp outboard power pack?

    Took my boat to a mechanic he said only 3 of the 6 plugs where firing properly, he suspected it was the power pack. I purchased a used pack installed it now there is no fire to any of them. I was told the pack was tested before shipment. Bad pack? or any other suggestions.
Top