Search results

  1. D

    8.1 GXI-J Cranks but No Start w/ Diacom Logs

    You could pull the plugs and turn the engine over and see if any water comes out of the cylinders. If it does then likely a manifold or riser problem. Seems to me you have two issues, loose head bolt and water in the oil. The only way they are connected is by what is now a head gasket issue.
  2. D

    5.0GL fuel small leak near the water fuel separator and possible starter solenoid issue

    You will need to inspect the pump housing to see if the repair kit or full kit is needed.
  3. D

    2004 Volvo Penta SX-M1 Outdrive Cracked Bellows.

    Pull the drive and get the bellows off. You can fix it in the spring. If anything is rusted and needs replacement you can order the parts. Some can take awhile. The Volvo Penta OXI and OceanX versions detect water in the bellows.
  4. D

    How to winterize aq151a - changed oil recently.

    Is it a FWC or RWC? If you have less than 10 hours on the engine oil I would skip changing it. Drive gear oil gets changed. Change the raw water impeller. Other winterizing steps depend on whether it's a FWC or RWC engine. The Volvo Penta owners manual has the information for winterizing...
  5. D

    multiple error codes

    I would start with a mechanical oil pressure gauge and a thorough cleaning of the connectors involving the ECM and sensors connected to it.
  6. D

    Volvo AQ Trim Module

    How much is a new one? You not only need to design it, you need to build it for the marine environment. A couple of years ago I looked for a module to control an electric fuel pump when converting from a manual fuel pump. I could not find one for the marine environment and went back to...
  7. D

    145 a volvo penta winterize procedure

    So winterizing in a FWC engine is different than a RWC. Since you mention antifreeze I assume it's a FWC engine. Test the antifreeze or extract a little and put in a Dixie cup in your freezer overnight. I would suggest you review the owners manual for winterizing instructions. Most are...
  8. D

    Volvo Penta V8-430-CE-M Overheating

    Melting of the impeller is typically because the engine was started without water going to the pump.
  9. D

    Maintenance on 20 year old VP 3.0 inboard.

    I would replace the thermostat. Make sure it's one for a RWC engine which I assume it is. I assume you pull the drive every year or two. Grease the u-joints. Check the alignment. There are probably things wearing out in the outdrive if it has not been rebuilt in 20 years.
  10. D

    5.0 GXi 2007 Metallic noise

    Remove the belt and run the engine for a minute. See if the noise goes away.
  11. D

    Bogging down

    Changing to an electric has its issues as you need to run the pump for 10 seconds when the key is first turned to ON and then run the only when the engine is actually running. Hard to get marine quality components to control the electric pump.
  12. D

    Volvo Penta 5.7 GI-FF Quits suddenly then will run only at idle

    I would look to find ways to keep the fuel cleaner. Additives (Blue marine Stabil). But fuel at a cleaner location. Use old fuel up.
  13. D

    Volvo penta 2 pin alternator wiring ?

    If you get the excite and sense backwards to alternator the alternator will still charge properly with the engine running but will discharge the battery when the key is off. And the alternator will get warm with key off.
  14. D

    1987 Volvo penta aq125a starting problems

    Maybe consider the kits that replace the points.
  15. D

    Best Alternator?

    +1 - local rebuild shop
  16. D

    2002 Glastron 175sx milky oil

    You have an alternator and a possible water intrusion. Water intrusion could be as others have mention water flowing back up through the exhaust after a quick stop. Or head gasket or exhaust manifold.
  17. D

    Any idea which drive this is?

    Volvo Penta manuals are the way to go. Shipped from Sweden
  18. D

    Trailering boat with outdrive struck down?

    Disconnect the rams and use a ratchet strap. Did this on a Mercruiser Alpha 1.
  19. D

    2007 Larson cabrio 240 beeping and in limp mode

    Well in this case you obviously replace the hose with a high quality but expensive VP hose. Is the alarm where it is as that's where it gets power from but signal to turn it on comes from elsewhere?
  20. D

    2007 Larson cabrio 240 beeping and in limp mode

    Why didn't the mechanic who could not recreate it scan for codes? Or did he? There could be pending codes or stored codes. Either get a mechanic with a Diacom or buy one. Need to scan codes from time time.
Top