Search results

  1. R

    Battery Question

    Have 3 batteries on my boat. 24v trolling motor. How or can I wire batteries to charge off a 2 bank on board charger. Any help appreciated.
  2. R

    Fuel Issue. Need Help

    Purchased a 98 Back Country flats boat with a 1996 Mariner 135 Serial# 0G 384616. When the boat was purchased the previous owner was running the boat on a 12gal. external/portable fuel tank, boat ran fine. I removed the portable fuel tank and reconnected the fuel line to the original fuel tank...
  3. R

    Throttle Adjustment

    How do you properly adjust throttle on a 83 Envinrude 25hp tiller. Model number E25RLCTE. When turning throttle to WOT it only opens carb about a quarter of the way. Thanks in advance.
  4. R

    Impeller Question

    Reinstalling the impeller in new water pump repair kit what is the correct way to install impeller into housing. Which way are the fins supposed to be pointing.
  5. R

    83 Envinrude 25hp Water Pump???

    Just fired up a 83 Evinrude 25hp model#E25RLCTE and I'm only getting drops out of the cooling pisser. I'm suspect to say water pump but is there anything else I can check before droping the lower unit. Not very familiar with this motor and could use as much help as possible. Thanks.
  6. R

    Switching From Tiller To Controls

    I have a 83 Evinrude 25hp model #E25RLCTE. Is it possible to convert this motor from a tiller over to controls. If so is there a kit available/or what is required to do the conversion. Input greatly appreciated.
  7. R

    Piston Question

    Having the block on a 40hp 4cyl honed (Engine Serial # 0G140839). The parts diagram shows the use of 3 ring piston or 2 ring piston. What is the difference and can I go with a 2 ring piston. Oil injection is removed and will run pre-mix.
  8. R

    40hp 4cyl. Powerhead

    Anyone know where I can by a remanufactured powerhead for a 1995 40hp 4cyl. for a reasonable price. Engine serial number 0G140839 Thanks.
  9. R

    Controller Question

    Looking to replace the controls on my 95 40hp. Outboard serial # 0G140839 Will this controller work. Mercury Part Number 881170A15. if not could someone point me in the right direction
  10. R

    Oil Injection Question

    I have a 1995 Mercury Tracker 40hp 4 cylinder. The oil injector/pump is not functioning. Is it possible to remove the oil injection system and run pre-mix instead of the oil injection without hurting the motor. If pre-mix is a option what would be the best mix ratio to run. Thanks
  11. R

    What year Mecury is this motor????

    Serial # 0G140839 It is a 4cylinder 40hp Tracker by Mercury Pro Series, and what is a good web site that has exploded parts view for this particular motor. Thanks.
  12. R

    Johnson Parts ????

    Will ignition parts from a 30hp Johnson (Model# J30EESS) fit on a 1999 Jonson 30hp (Model#J30ELEEC).
  13. R

    Spark Plug Gap ??

    Is .030 the recommended spark plug gap for a 1990 Johnson 90hp. Thanks.
  14. R

    Flywheel Magnet ???

    I have a 1999 Johnson 30hp (model #J30ELEEC) with damage to the flywheel magnets due to a faulty repair and I have been unable to locate a used flywheel for the motor. My question is, are the magnets replaceable or do I need a new flywheel. I know Johnson does sell magnet repair kits but have...
  15. R

    Will This Flywheel Work

    Looking for a used flywheel for my 1999 30Hp JOhnson 2 cylinder Model #J30ELEEC. I have a located a used one with a part number of 583001 and a casting number of 583002. Does anybody know if this will work or the part numbers of the the flywheel that will. Thanks.
  16. R

    Flywheel Help

    Trying to locate a used fly wheel for Johnson 30hp (Model# J30ELEEC) 2 cylinder electric start. I have found two part numbers 0585158 and 0583001 and a casing number of 514516. Are these the correct parts numbers and are there others that will work. Having a hard time locating one.
  17. R

    Need Fly Wheel

    Anyone know where I can pick up a fly wheel for a good price. It is for a 1999 Johnson 30hp (J30ELEEC)
  18. R

    1999 Johnson 30hp ?????

    Was out fishing Saturday when my motor decided to quit, not sure if it is a blown motor or lower unit. I'm by no means a mechanics, but I do no that I'm unable to move the fly wheel. What can I do to diagnose the problem and try to determine if it is the motor or lower unit. Any input greatly...
  19. R

    99 Johnson 30hp Fuel Problem

    Have a 99 30hp johnson. Motor has been running fine until today when I went to start it before a fishing trip. Motor turns over but will not fire. I poured gas into carb and motor will start then shut off when the fuel is burned up. Checked the fuel line into the fuel pump and it is getting...
  20. R

    99 Johnson 30HP Help

    99 Johnson 30hp at WOT motor cuts out but does not lose power. Sounds like the motor is hitting a rev limiter, but I don't think this motor has one. Where should I start my troubleshooting to eliminate this problem. Any input greatly appreciated. Also motor runs perfect except at WOT.
Top