Search results

  1. R

    How to count teeth bravo outdrive ratio

    I have a B-2 with a B3 dual,prop foot, I bought this drive used and it works great but I've had other boat issues with low rpms and starting to think the ratio on my outdrive is wrong for my boat. I need and thought I purchased a 2.20 ratio as stated on the side case but seeing this drive has...
  2. R

    Trailer hitch alignment made easy ideas?

    I was looking around the web for a trailer hitch camera or a non electronic hitch to receiver helper. I think. After reading camera reviews I'm leaning more to a non camera tool such as never miss or even the old tennis ball setup. If I were to use a camera system I'd want it simple wireless and...
  3. R

    FYI stain remover for carpet and more

    Sorry I just had to post this and some may already know. I had a few greasy foot prints that would not come out in my boat carpet and I happened to look up and see a can of PB Blaster and said why not. So the carpet was already wet and I sprayed some in the stain rubbed it just a little and the...
  4. R

    2000 bravo 5.7 efi timing question

    On my boat with 5.7 EFI I only have a V mark on timing cover and a notch on the balancer. With A-B terminals jumpered is 8 degrees center lined or is it starbrd of the V mark on timing cover?
  5. R

    2000 5.7 EFI BRAVO 3 fuel cutting out at 3,000 RPM

    I have a rinker 270 bravo setup and have just placed a new engine in this boat. Fuel tank was in bad condition lots of water and trash but think I have cleared the tank up enough to look at another problem. Boat has new fuel pump and regulator new injectors too. I read an old thread in here were...
  6. R

    Broke tab off retainer nut replacing ujoints

    Yep I did it and knew better but was at friends house and didn't have the proper setting to do this job. So 1999 alpha one gen 2. I knocked a pretty large tab off the retainer nut when removing ujoints. Would this cause a steering knock hard right and hard left? I actually think the knock is...
  7. R

    Temperature jumps from 125 -200 and back quickly

    I have a 1999 ebb tide with merc 5.0 and alpha one gen two. I just did a complete bellows make over and replaced the drive impeller. Last year when I parked the boat it was running fine. This spring I decided to do the impeller, gimbal and ujoints because they hadn't been done that I knew of...
  8. R

    Which direction to install bravo 3 prop nut

    I purchased new prop nuts for my bravo 3 and don't know which direction to install them? Does the Teflon end go on first or reverse? I don't have a reference from original because it's a repower. Thanks for any response
  9. R

    Engine and generator wiring diagram for 2000 Rinker 270 5.7 EFI

    I need help please, I've repower a 2000 rinker 270 and the boat has been apart for months and can't quit figure out the kolher 5 generator wiring..... Would anyone have a diagram on how to properly wire everything back in...... Pictures of your rinker would be a great visual too!!
  10. R

    2000 Rinker 270 soft transom help

    I bought this boat a few months ago, knowing the bravo 3 needed replacing.... Boat did run but when I got her home it all got bad and then worse...... I then discovered a leaky fuel tank and did my research and was convinced the tank had to be removed, so I cut the aft cabin flooring out and...
Top