Search results

  1. J

    Need Opinion of 1990 140 HP Envinrude

    I was also looking to buy another engine: 1990 140 HP - Envinrude. Brand new power head - 50 hrs. What do you think of this engine? It has the separate oil tank for the VRO. But I would prefer to mix my oil w/ the gas. Is that OK? Overall, is this a good engine?
  2. J

    Hesitation at 3/4 speed

    I have a 1989 100 HP Johnson - V4. I have a water separator and an in-line fuel filter (one of those small white plastic filters) I never had the fuel filter but I put one in for added protection. However, my engine would hesitate and drop RPM while I was going for about 10 - 15 minutes at...
  3. J

    Too many VOLTS

    I have a 1986 115 6 cycl. Volts read 12 when idle. As I increase speed the volts go up. At full speed the volts read 15.5 - 16. I have also noticed the fluid in my battery is running low. If I hit the power trim when the volts are up to 15.5, they go down to 12 and than go right back up to...
  4. J

    Electric Tilt

    I have a 4 cyclinder 100 hp Johnson - 1990 - rebuilt in 1999. I removed the engine off my transom and put on a stand in my garage. However the engine is tilted up a bit. Is there a way to lower the tilt with out battery power? Is there a manual override to release the Hyrdralic pressure?
  5. J

    Flushing out the engine

    I have a 1986 115 Merc - 6cyc - Rebuilt in 1999. I use the engine in salt water. When I bring it home and flush out the engine with the "ear muffs" I noticed that the water turned a little brown. Is that just the exhaust........?
  6. J

    Gas leaking out of Carbs

    I have a 1986 115 Mercury - 6 cyc. After running the boat for a few hours, when bringing the boat on the trailer, we have to raise the tilt on the engine. Is it normal for a little gas to drip out of carbs? I was an Evinr/Johnson guy before this merc. I notice the Merc does not have a cover...
  7. J

    Voltage Meter

    I have a 1986 115 Mercury in-line 6, re-built in 1999. My voltage meter reads 12-13 volts when I turn the key but when I start the engine it shoots up to 15.5 volts, especially when I am increasing the RPM's. Than if I throttle back down the Voltage goes back down. In addition, if the Voltage...
Top