Search results

  1. P

    Johnson 02 90hp overheat horn not working

    When I turn on the ignition I get a short beep and the lights come on and go out one by one. If I short the tan wire to ground, the overheat light comes on but no sound is heard.
  2. P

    Johnson OIS 2000 Questions

    I have installed a CDI 113-6292K 1 power pack on my ?02 90hp Johnson and am trying to set the timing per CDI instructions. I am using a remote starter switch to crank the engine. I have disconnected the port timing sensor Tan and White/Black wires and grounded the Tan wire. When I crank the...
  3. P

    Johnson '02 90hp bad charge coil?

    Has anybody heard of a charge or power coil going bad? I suspect that I have a problem with mine but don't want to spend the money if they never fail. Thanks, John
  4. P

    2002 90 hp Johnson stalls under load

    I have an intermittent problem: When it happens: I can put it in gear but when I advance the throttle even slightly, the engine stalls. I can restart it but then the same thing happens. If I leave it in neutral I can rev it up and then when I put it in gear it's OK for a while. My thought...
  5. P

    2002 Johnson 90 stalls when throttle advanced

    This happens frequently but not always. Starts and idles OK and will go into gear without stalling but when I advance the throttle it dies. Will restart without problem. Sometimes it will run fine for 15 or twenty minutes and then will just die when moving along at about 2500 rpm. When it...
  6. P

    90 hp 2002 no spark

    I have no spark on any cylinder. I have the factory manual and it says (pg 111) to disconnect the port Packard connector and see if there's a spark now and there is. The manual says the problem is in the stop circuit. It then says to check the black/yellow wire to ground with an ohmmeter. I...
Top