Search results

  1. R

    96 Evinrude 50 Cutting Out

    Where did you look on the parts break down.-----We need to know if it is a 2 cylinder motor or a 3 cylinder motor.----Model # is ?
  2. R

    1986 Mercury 90 hp 6 cylinder only running on #2, 4 and 6 cylinders

    Sounds like a bad switch box.-----There are of them.----You could test by swapping them and see if there is no spark on 1 , 3 and 5 and spark on 2 , 4 and 6.
  3. R

    96 Evinrude 50 Cutting Out

    Salty are you sure this motor has a 2 wire heat sensor , along with limp mode ?
  4. R

    Choke stays closed

    Stop hooking up wires in the hope it fixes it.----Run to a shop that can solve this in minutes.
  5. R

    1986 90hp Mercury inline 6 won't start

    I doubt you will find a flywheel key on an inline 6 model.
  6. R

    Johnson 40hp 2005 link and idle adjustments

    The first thing to do with your motor is a compression test.----Post the actual values here.
  7. R

    1994 Johnson 150 HP

    If it revs up before stalling , I think it is running out of fuel.
  8. R

    Choke stays closed

    There is a spring affair on the choke linkages.----A much mis-understood item.-----Maybe a previous owner was baffled by it and hooked it up wrong.----Remember we can not see , hear or feel your motor !
  9. R

    1972 Evinrude 40 outboard no spark?

    In good condition and adjusted properly the idle very nicely !----Who told you they are " lumpy" at idle.
  10. R

    1993 Evinrude 70hp Missing Prop, Seeking Recommendations

    13-1/4 or 14"---diameter for 70 hp.
  11. R

    96 Evinrude 50 Cutting Out

    Sounds like it is running on 1 cylinder.---Does spark jump a gap of 3/8" or more on both leads ?
  12. R

    Does Tohatsu make motors for Mercury or vice versa?

    Some Mercury 4 strokes were also built by Yamaha.
  13. R

    1998 Johnson 115ELECM vapor pump

    Saw 4 rebuild kits on a dealer counter a few weeks ago.------Factory kits come with complete instructions.
  14. R

    Choke stays closed

    Cyclops is totally wrong with his choke thinkings and assumptions.
  15. R

    Choke stays closed

    ???-----This motor just has a simple choke set up-----Closed or open only.-----No fancy adjustments of any kind !!----These carburetors do not have idle mixture screws either !
  16. R

    Top speed

    Could be a rev limiter.----Try a prop with 4" more pitch and test run.
  17. R

    Choke stays closed

    Choke solenoid should only work when you command it to be closed.-----Your wiring is incorrect.----Do something about before damage occurs.
  18. R

    1971 Evinrude Fastwin Fuel Gremlin

    Lots of those left the factory with electric start.-----I do not know of an aftermarket kit !
  19. R

    1990 Evinrude 3HP, dies when throttle opened more than half

    They say-----" the bitterness of poor quality is remembered long after the sweetness of low price is forgotten "
  20. R

    need help no start

    Need to confirm the model #---- Not sure if that model # existed in 92-----Unless it is a -----E150GLENC-----?????
Top