Search results

  1. C

    175hp ocean pro WOT rpm

    I finally got out to test a new to me boat a 22' hydrasport with a 1996 175hp ocean pro. I was getting about 4400rpm at WOT and 32 mph. The boat is rated for a 300 so I know I'm a little underpowered. I would like to get up to 5000 rpm atleast. The current prop is a 15x17. Would a 15x15 prop get...
  2. C

    1980 J5rlcs 4.5hp Dies underload

    I have a 4.5hp I use as a kicker for my 18ft starcraft. The problem is when running in a tank it is fine but when trolling it will go for maybe 3-5 minutes then die. This motor is a gravity fed fuel tank, to me it seems like it is not getting fuel? So far I have changed the fuel filter but no...
  3. C

    Throttle drag adjustment ?

    I have a 1980 4.5 hp Johnson and I was wondering if anyone could tell me how to adjust the throttle drag on the tiller. I wanna be able to set the tiller at a speed and leave it, so I don't have to keep my hand on it.
  4. C

    18ft starcraft super sport repower

    Was looking to repower my 18ft 1976 18ft starcraft. I can get a good deal on a 4 stroke mercury 60hp is that gonna be underpowered? I know a 70 or 90 would be ideal but cant beat the deal for the 60.
  5. C

    1989 70hp upper crank seal

    Hey guys I have a 1989 70hp evinrude and i noticed some oily residue under the flywheel, not a whole lot but some. Motor runs and idles great also is running on the top cylinder( if i pull the spark plug, it changes). My question is, is the somthing I should get replaced soon? or is a little oil...
  6. C

    Chine reinforcement?

    I have a 1975 18ft ss I am rebuilding, I have seen from doing research that the 70's starcrafts have been prone to cracking in the chine. I was just wondering if anyone has done anything to reinforce the chine or just leave it at is.. there is no cracking on my chine, just looking to see if...
  7. C

    Is there a service bulletin for evinrude 89' E70TLCEM

    I have an 1989 evinrude E70TLCEM 3cylinder and was wondering if anyone had the service bulletin for the Tstat and seal and the Temp switch this outboard or if there is one? I have researched on here and found information about new parts for these. I just want to make shure they are for my...
  8. C

    will it crack?

    Over the winter I discoverd a couple pinholes in the bottom of the rivited hull and had them weld a patch over the area. my question is does anyone think the hull will crack around the welds? I have had it out handfull of times since repair and has been fine no issues.
  9. C

    Welding a rivited boat?

    Are there any problems with welding a rivited boat? Looking to get a patch welded in just wondering if anyone has any experience before i take it to the welder.
  10. C

    holes and Pitting in hull (pics)

    I have a 19ft sea nymph GLS 1988. I just bought this boat this winter and notice some corrosion on the bottom side of the hull. After seeing this i decided to remove the wood floor( which was waterlogged) and the foam floatation which also was very waterlogged. I found this corrosion which is...
Top