Search results

  1. S

    Engine height or prop?

    I've got a 20' cc with a 99 150 Johnson hanging on a transom bracket. The bracket extends out 22". The prop is 15x17 stainless. With motor trimmed down my cavitation plate is around an 1 1/2" above keel. I've read that for every 12" of set back it should be raised an 1". It takes a while to get...
  2. S

    Leaking Carb!

    I've got a 99 Johnson 150 ocean pro that has a carburetor on it that want stop leaking. I've put new seat and needle in it along with float and other seals and o-rings that come on the kit. At first it was coming out of the main nozzle of the carb and from time to time it would seal up not leak...
  3. S

    Transom bracket+motor height ?

    I have a transom bracket with a Johnson 150. Rite now trimmed all the way down my cavitation plate is about 2 1/4 above the bottom of hull. The bracket extends 22" back. I know when I come off of a plane to an idle the water washes up against the motor up on the cowlen. Can I raise my motor up...
  4. S

    Sanding carb bowls?

    I've got a 99 Johnson 150 ocean pro that seems to be leaking around the top of the bowls. I can clean it all with carb cleaner and after a short run on the water or on the hose they will be wet. Bowls look like they might be worped. I've read where some people say to wet sand the bowls to make...
  5. S

    Starts then shuts off!

    I have a 99 Johnson 150 Ocean Pro. It starts up so well cold and will run for approximately 2-3 mins and then start spitting and spuddering and shut off and will not restart unless it sits for a couple of hours or so and will bust right off again. I just got this boat and has run fine on a hose...
Top