Search results

  1. Scott Danforth

    VP 5.7 GXI Tachometer Sending unit

    most tachs run off the coil unless they are networked gauges, then they run off the CAN backbone
  2. Scott Danforth

    VP 5.7 GXI Tachometer Sending unit

    the tach is connected to the coil. the ignition firing the coil is what sends the signal to the tach. hint: its the grey wire
  3. Scott Danforth

    Winterize Tohatsu 50hp 4-stroke on boatport . . .

    if the lift doesnt go high enough to get the leg out of the water when the motor is straight down, either remove the boat from the lift, or the motor from the boat. or the lower can bust like this.
  4. Scott Danforth

    Thermostat closing position

    correct
  5. Scott Danforth

    Grease Zerk Fitting Question . . .

    rebuilding holley carbs and using a grease gun helping dad
  6. Scott Danforth

    Grease Zerk Fitting Question . . .

    because people like movies, here is a facetube clip on adjusting the end fitting on the gun.
  7. Scott Danforth

    Grease Zerk Fitting Question . . .

  8. Scott Danforth

    Grease Zerk Fitting Question . . .

    the end fitting on your gun should be adjustable. righty-tighty, lefty-loosy
  9. Scott Danforth

    Thermostat closing position

    all marine thermostats are used as mixing valves and not true shut-off valves. in the outboards, there is constant flow
  10. Scott Danforth

    Wondering how much my latest boat weighs.

    based on the pictures, the boat needs a full cap-off / engine & drive out restoration.
  11. Scott Danforth

    Boat leaking salt water - steering pin?

    based on this pic and some of the others, I would have the boat on the hard, the motor out and be pulling the transom shield
  12. Scott Danforth

    Wondering how much my latest boat weighs.

    No, it will never dry out and be back to usable foam Yes you can remove and replace Go to the stickies at the top of the restoration forum
  13. Scott Danforth

    How bad of an idea is this for OB support while trailering?

    Just like a motor de-flopenizer (AKA transom saver).
  14. Scott Danforth

    How bad of an idea is this for OB support while trailering?

    could always use a motor de-flopenizer (old iboats term)
  15. Scott Danforth

    Mercruiser Motor identification

    See post #8
  16. Scott Danforth

    self leveling or motorized trim tabs

    I would run Bennett sport tabs, All trim manufacturera have sizing recommendations
  17. Scott Danforth

    Random

  18. Scott Danforth

    Resistor wire

    Moved the thread to the Mercruiser section
  19. Scott Danforth

    Raven BR190 1988 3.0 Restoration

    6 months is extremely aggressive schedule for a 1988 fiberglass boat
  20. Scott Danforth

    Slx 350 steering wonders Axius

    2016 350 SLX and anxious should be twins
Top