Search results

  1. S

    Calorifier question?

    Hi, I have a brand new Mercruiser 6.2L 350HP V8 recently installed with a Bravo3 Sterndrive. Does anyone have a picture of the engine water take-off points for a calorifier? I have the manual and the correct kit but this only shows a partial schematic and its probably me being thick!!, but I...
  2. S

    Bravo 3 Prop selection - other options?

    Hi I have a Mercruiser Bravo 3 drive and I have been speaking to the owner of an almost identical boat and same engine, his boat was tested with a set of test props and then the engine running data ran through the mercury prop selector tool and they came to a conclusion of 21" props. This gave...
  3. S

    Installing Bravo3 Sterndrive

    Hi, I wondered if someone can help please. This is the first time I have tried installing a Bravo 3 Sterndrive and it seems to be stuck at the point shown in the photo. I cannot seem to get it passed the threads although everything “appears” to be lined up and well greased. This is a brand new...
  4. S

    Bravo 3 Dribble valve.

    Dumb question alert. – newbie to Mercruisers. All new Bravo 3 installation and I just need to install the sterndrive. However, before installing the sterndrive the manual states “With the gear lube monitor cap removed; to purge air from the system, push in on the dribble valve stem until the...
  5. S

    Bravo 3 steering sensor and Trim sender and trim wires, DTS adaptor cables?

    Hi, probably a long shot but worth asking as I have spent hours searching for answers. I have installed a new Mercruiser V8 6.2l engine with Bravo 3 Drive and struggling with 2 connections. The Engine has Smartcraft instruments and a DTS Console. And most of the connections are fairly...
  6. S

    Bravo 3 engine installation / alignment

    Hi wondered if anyone could help please. Trying to install the engine and I believe am missing something. Everything was lined up and the rear mounting bolts all installed and located into the bottom nut. The spacer is proud of the flywheel mounting fixing by some margin and there is a large...
  7. S

    Mercruiser Bravo 3 Gimbal Housing assembly - transom installation.

    I wondered if anybody can help please. I am installing a Mercruiser Bravo 3 Gimbal Housing assembly in a newly modified transom. I have the proper Mecruiser cutting jig to drill the holes and mark out the cut-out on the transom and the 60 degree angle holes for the hole saw to install the...
Top