Search results

  1. S

    Starter or solenoid ?

    Seems like something is stripped in the starter. You can hear something spinning.
  2. S

    Motor won’t turn over

    I'm thinking the nutruel safety switch on the starboard side.(mines on that side) When in nutruel it grounds the soloniod which makes it work. To test, put a jumper from any engine ground to one of the small leads on the solenoid. Should be the one closer to the back or the one that DOESNT have...
  3. S

    Mercury 25hp EFI Sucked Up Debris, Overheat Alarm

    Good to hear you were successful and thanks for letting us know!
  4. S

    6.5 hp evinrude start but won’t run

    Didn't know that was a video....that's not running at all. Check for GOOD spark.
  5. S

    Lower unit stripped drain plug

    I'm not really good at putting them in but I wonder if you could put a heli- coil in.
  6. S

    6.5 hp evinrude start but won’t run

    Try pumping the primer ball when it first starts up.....if that doesn't do it then you will probably need to go through the carbs.
  7. S

    e50tslecc evinrude

    You have something very strange going on. If you can post a video of the carbs opening and closing with the motor off.
  8. S

    Should I buy this 1973 Evinrude 65 triumph?

    I would tell him you will haul it for free.....which might be to much.
  9. S

    Stuck water pump impeller

    Good to hear....happy fishing.
  10. S

    2014 20 hp overheat sensor?

    Is this a tiller motor?
  11. S

    2014 20 hp overheat sensor?

    Kelp is tough to get through, sure it's not just your prop trying to get through it?
  12. S

    Johnson 9R-73B fuel leak

    Online or your Evinrude dealer....or whatever they call themselves now.
  13. S

    Johnson 9R-73B fuel leak

    The fitting from the tank doesn't look new in the picture. Anyhow, I've had problems with the aftermarket ones.
  14. S

    Mercury 80hp pop/backfire out exhaust

    It's not a backfire, I'm wondering if because it has no back pressure on it it's just behaving normal. Motors are set up with a load on them. Have you tried it in the water yet? It may be fine.
  15. S

    Johnson 9R-73B fuel leak

    Often times it's a cheap fitting that comes on the fuel line or did you make sure it fits to a Evinrude? I assume you pushed it all the way on until it clicked? Yes, there is a seal in there.
  16. S

    Blown head gasket / overheat

    Good to know, maybe this will help others.
  17. S

    2016 etec 90 hp skip after injectors cleaned and 1 new

    There is a little more info on etec's over in this forum. https://www.etecownersgroup.com/
  18. S

    2001 Johnson 50hp

    Sounds like you had a runaway motor event.
  19. S

    Johnson V4 Crossflow Throttle return

    Was it on a different thread? Doesn't show it on mine when I go back, weird.
  20. S

    Overheating at idle, cool as a cucumber at speed

    I'm thinking you plugged the intake screen and possibly burned up part of the impeller and the rubber bits are moving around causing havoc. Pull the lower end and look at the water pump. Should tell the story.
Top