Search results

  1. R

    Looking in installing a regulator rectifier

    Post #2 asks for a model #-----And to me post #3 clearly indicates to me that the model # is needed.-----No such thing as a 110 HP in 1975.
  2. R

    Looking in installing a regulator rectifier

    I doubt it is a 1975 model !!----Well , yes most Evinrude motors are water cooled !----Post model # or pictures for further help on this topic.
  3. R

    20 Hp mercury thunderbolt ignition year?

    Those decals were used in 1980 and 1981.
  4. R

    Looking in installing a regulator rectifier

    Model # of your motor ?----The stator under the flywheel charges the battery.----Models without power trim / tilt had a rectifier.------Those with trim / tilt did come with voltage regulator.-----Regulator would be found on top of the block.----It is water cooled.
  5. R

    Santa brought me Smart Tabs.

    I think 60E is for Bracebridge area.
  6. R

    Santa brought me Smart Tabs.

    Buzz----Where in Ontario did the boat come from ?
  7. R

    Inboard Engine Cover is Really Heavy

    Does boat have a top / cover when not in use ?-----Best to inspect the rest of the boat.----Perhaps a trip to a weigh scale if on a trailer.
  8. R

    1967 5hp Eska selling price

    Just a noisy , cheap and air cooled Tecumseh lawnmower engine.----For $200 there are far better motors available.
  9. R

    Swell, waves, and period

    Huron , it is.----Been at Port Sanilac during yacht racing stop over.
  10. R

    Swell, waves, and period

    Surface of the lake is 23,000 square miles/
  11. R

    Swell, waves, and period

    I have seen a Seiche more than once.-----The lake where I am located is fairly big.-----I can not see the shore on the other side.
  12. R

    Swell, waves, and period

    On the lake in my area you can have 6' to 8 ' waves during a windy day.----Then if the wind dies down the waves keep rolling along and it takes the swell a few hours to die down.
  13. R

    1977 Evinrude 35hp Corrosion

    Motor needs to come apart if you are hoping to enjoy operating it.
  14. R

    #2 / #5 Cylinders Not Firing

    What about the " oil level gauge " ( switch ) in the tank on the motor ?
  15. R

    ‘63 Evinrude 3302s 3hp questions

    Tighten the packing gland nut.----A 7/16" wrench does the trick.----Would not hurt to add a couple of packing washers.
  16. R

    Evinrude 115Hp V4 Project Rebuild / Repowering a Fourwinns Fling Turbo jet boat

    The service bulletin came out in 1994 to deal with the 3 cylinder 56 cube motors.------Many folks have gone overboard and applied this to every outboard !!
  17. R

    ‘63 Evinrude 3302s 3hp questions

    Water must be 8" above the impeller in a test bucket.
  18. R

    Evinrude 115Hp V4 Project Rebuild / Repowering a Fourwinns Fling Turbo jet boat

    Where did you read / learn about ---" airlocking " ---on this turbojet ?
  19. R

    Boating YouTube channels

    I used to sit at a launch ramp on weekends for entertainment.---50 years ago, no different today.
  20. R

    Dual fuel pump line diagram

    Fuel from tank goes to one pump.----Output from that pump goes to intake of second pump.----Output from second pump goes to carburetors.
Top